General Lab Safety
What is the required equipment to wear in the shop?
What is Safety Glasses?
What should be done with long hair when operating a drill press?
Tie it back close to your head and keep your head away from moving parts
What industrial quality protective equipment should be worn for protection?
What is Ear Protection?
When sawing a small stock, you should always use a?
What is a Push Stick?
What is the purpose of a stop block?
What is Improve cut accuracy and reduce the time required to make more than one cut?
A student is permitted to leave the laboratory only with?
What is with instructor's permission?
What type of drill press chuck should be used with a straight shank twist drill?
What is Jacob's chuck?
What type of stocks should never be ran through the planer?
Relief cuts are cuts made with the band saw. ___
What is They prevent the blade from binding?
How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw?
What is a Safe Speed that will not burn or splinter
While performing work in the laboratory, one should not _________?
What is disturb other workers?
To select the proper drill bit, one should check what?
What is Check the size, sharpness, and type of shank?
Lumber should be fed into the planer.....
What is with the grain?
How should you feed the wood through the blade on the band Saw?
What is slowly and carefully?
What type of cut is being made when only the arm tilted?
What is a bevel cut?
Approved safety glasses can be identified by?
Which is not a safe way to secure stock while it is being drilled?
What is Hold it firmly by hand, but securely on the drill press table?
Why should you never stand or directly walk behind the planer when it's in operation.
What is kickback may occur causing a serious injury?
If it is necessary to back the blade out of a cut, what should be done?
What is turn the power off and free the blade?
What type of cut is being made when the arm and the base is tilted?
What is Compound Miter?
Shop clothing is unsafe if it is?
What is Baggy, Loose and Flammable?
After the drilling is finished, which of the following should be completed first?
What is Turn off the drill press?
What is an Off-Bearer
If you hear or feel a rhythmic click as the wood is being cut, this usually indicates that...
What is the blade being cracked?
What special protection must be observed when using the motorized miter saw outside?
What is a ground fault circuit interrupter (GFCI)?