Leadership
energy to do a job and the inspiration to encourage others.
What is enthusiasm?
Wood or metal forms should be treated with _____ and wet down with water before concrete is poured.
What is oil?
Air filter is serviced by replacing
What is dry type?
____________ the ends and center of a weld will help reduce or prevent warping.
What is tacking?
Safety color green should the location of ____________
What are first aid kits?
Honesty; doing the right thing
What is integrity?
Water rising to the top surface of concrete poured in tall or deep forms is called ________.
What is bleeding?
fuel tank should be empty to prevent “_____________"
What is gumming up?
________ welders are usually less expensive than DC or AC/DC welders.
What is AC?
To end up with the correct length piece of metal, sawing should be done on the waste side of the mark. Cutting out the mark will make the metal ____ _____
What is too short?
reliable support for an individual, group or cause.
What is loyalty?
L(ft.) x W(ft.) xT(ft.)
__________________
27
What is the formula above?
What is cubic yard of concrete?
air filter is serviced by washing it to remove dirt and then squeezing oil into the filter which is usually foam rubber.
What is oil type?
If a bead has slag, the ____________ should be removed between each pass if a multiple pass weld is used.
What is slag?
2+2
What is 4?
willing to go forward under difficult conditions
What is courage?
using a straightedge such as a 2" x 4" board to level concreter with top of forms.
What is screening?
recommended service is to replace rather than clean or repair (think spark)
What are sparkplugs?
Proper hand protection requires __________ to prevent burns
What is welding gloves?
If a pipe has a small leak, a ______ ________ with adjustable hose clamps can be used to make temporary repairs.
What is rubber blanket?
Saying or doing the right thing WITHOUT offending
What is tact?
__________ are dug in the ground for footings of buildings, and the soil walls are the forms
What are trenches?
3 things for an engine to run?
What is fuel, ignition, and compression?
The size of electrodes is determined by the __________ of the electrode on the bare end (metal ______ not including flux).
What is diameter?
Who is your favorite ag mech 2 teacher?
Who is Mr. Weems!