EQ 1
This can be used to remove unwanted low frequencies from a guitar track.
What is a high-pass filter?
This EQ type removes high frequencies above the cutoff frequency.
What is a low-pass filter?
This Pro Tools session parameter, measured in hertz, cannot be changed after the session is created.
What is Sample Rate?
A new audio track can be created by holding the ______ key and double-clicking the blank area below the track list.
What is command?
This can occur when two or more instruments with similar frequency content are played together in a mix. .
What is masking?
An EQ processor allows users to adjust these two waveform characteristics.
What are frequency and amplitude?
This is what determines whether to use EQ before or after compression on a track.
What are your mixing goals?
This Pro Tools feature allows you to save and recall views and positions for all of your windows.
What is Window Configurations?
This style of EQ typically contains 31 fixed frequency points and and a fixed bandwidth.
What is a graphic EQ?
Decreasing this parameter allows you to attenuate or boost a wider bandwidth of frequencies.
What is Q?
Sample-based material references an absolute timeline while tick-based material references a ________ timeline.
What is a relative timeline?
!! DAILY DOUBLE !!
Durations on ___________ timelines cannot be changed by changing the session tempo.
In addition to high and low pass filters, this type of filter allows you to affect frequencies above or below a cutoff frequency.
What is a shelving filter (shelf)?
!! DAILY DOUBLE !!
Sound waves that have a slower push and pull (compression and rarefaction) create these types of pitches.
This is indicated by a red playback cursor in the ruler of the edit window.
What is a record enabled track(s)?
What is a routing folder?
Using EQ in this way helps tracks with similar frequency content fit together into a mix.
What is complimentary EQ?
This is a build-up of a specific frequency or frequency range, commonly caused by improper mic placement.
What is resonance?
This type of hardware buffer setting is best used when recording onto an audio track to reduce the delay or echo heard when recording a live track.
What is low-latency?
This I/O setting can configure Virtual Instruments to automatically go through a specified bus.
What is a Default Output Bus?