FAAD INITIALIZE
What is the size of the FAAD Master Grid
819x819 km
Who confirms the DLRP
ABMOC/TP C2
What are the two operating states of the FAAD software?
Connected (operational) and Disconnected (offline/break)
What serves as the basis for the Area of Interest (AOI) air track filter extension, alert thresholds, and saturation alleviation function?
Supported Unit Boundary (SUB).
What is the SINCGARS Data Rate
2400/2400N
Where is the ABMOC located?
Division TOC/Main
What is considered the Primary organic Air Track source
Sensor C2
What does Air Defense Warning condition Yellow mean?
An attack by hostile aircraft and/or missiles is likely to occur in the near future.
Describe the three Weapons Control Orders.
HOLD: Weapon systems may be fired only in self-defense, in defense of a defended/protected asset, or in response to a formal order.
TIGHT: Weapon systems may be fired only at targets positively identified as hostile.
FREE: Weapon systems may be fired at any target not positively identified as friendly.
Which 2 Radios are used to transmit data to Fire Units
SINCGARS, EPLRS
What must the Initial Broadcaster in each FAAD Network do?
Build a ULT
Who is the Primary Air Track ID Authority
ABMOC/TP C2
What does the letter 'S' below a track indicate?
Simulated track.
What is the maximum number of entries available in the ULT?
253.
Which Data Cycle allows for Message Acknowledgements
2+2 with C2
What are the 8 FAAD IDs that are hard-coded into the software?
001 - AB, 002 A2C2, 003 - S1, 004 - S2, 005 - S3, 006 - S4, 007 - S5, 008 - S6
How many ports and channels are available for each TCIM
4 ports (J1/J2 SINCGARS)(J4/J9 EPLRS/MIDS)
2 Channels
What is the maximum number of Control Measures that can be displayed on FAAD?
40.
What is the range of local FAAD track numbers?
0001-4095.
What is used as an interface between the FAAD Workstation and the Radios?
Tactical Communication Interface Module (TCIM)
What must you do when you walk away from you Workstation?
Shift Change procedures (F11 / F12)
What are the 5 areas is the Operational Screen broken down into
Title Bar, Control Panel, Navigation Bar, FAAD3D BSD, Information Bar
What is the maximum number of air tracks that can be displayed on FAAD simultaneously?
210.
What is the difference between a Weapons Control Order and a Standing Weapons Control Order?
Weapons Control Order: Applies to a particular control measure.
Standing Weapons Control Order: Applies to the entire SUB, except for control measures with a WCO.
What are the Data Cycles for the SINCGARS
(2), (2+2) with relay, (2+2) with C2, (2+2+2)