Show:
FALL PROTECTION
ANCHORS
HARNESS & LANYARDS
HEIGHTS
VIOLATION
100

What is HEIGHT THAT FALL PROTECTION IS REQUIRED IN CONSTRUCTION?

Qué es LA ALTURA QUE SE REQUIERE PROTECCIÓN CONTRA CAÍDAS EN LA CONSTRUCCIÓN


6 FEET

100

What is the AMOUNT OF WEIGHT THAT An ANCHOR POINT MUST SUPPORT?

¿Cuál es la CANTIDAD DE PESO QUE DEBE SOPORTAR UN PUNTO DE ANCLAJE?


5000lbs

100

Where should the dorsal ring on the harness rest?

¿Dónde debe descansar el anillo dorsal del arnés?


between shoulder blades

entre omóplatos


100
18 TO 19 FEET
HOW HIGH OFF THE FLOOR DO YOU HAVE TO TIE-OFF TO STOP IF YOU FALL WITHOUT HITTING THE FLOOR
100
YES, THE SIDES
IS IT A VIOLATION IF YOU ARE WORKING ON A SCAFFOLD THAT HAS GUARD RAILS ON THE FRONT AND BACK OF A SCAFFOLD, WHY
200
What is the trigger height that fall protection is required at Sonoco?


¿Cuál es la altura del gatillo que se requiere protección contra caídas en Sonoco?


4 FT
200

A Full Body Harness will _____________the forces to the major muscle groups of the body.

 arnés de cuerpo completo _____________the fuerzas a los principales grupos musculares del cuerpo


distribute

distribuir


200

What is the max weight in most Full Body Harness (FBH)?

¿Cuál es el peso máximo en la mayoría de los arneses de cuerpo completo (FBH)?


130-310lbs


130-310 libras


200
42" +/- 3"
HOW HIGH DOES A HAND RAIL HAVE TO BE POSITIONED
200
TRAINING
What is ONE THE MOST SITED FALL PROTECTION VIOLATION THAT THIS TRAINING WILL SATISFY FOR US
300

What size holes need to be covered?

Qué tamaño de agujeros deben cubrirse?


2" or larger must be covered


2" o más debe estar cubierto


300

What is AMOUNT OF WEIGHT THAT A RETRACTABLE LANYARD MUST SUPPORT?

¿Qué es la CANTIDAD DE PESO QUE DEBE SOPORTAR UN CORDÓN RETRÁCTIL?


5,000lbs

300

What is the Energy Absorbing Lanyard average arrest force?

¿Cuál es la fuerza de detención promedio del cordón absorbente de energía?


900 LBS


 900 libras


300
4"
HOW HIGH DOES A TOE-BOARD NEED TO BE
300
RETRAINING
What is THE MOST COMMON WAY TO MAKE SURE THAT AN EMPLOYEE WHO HAS BEEN TRAINED BUT CONTINUES TO INADEQUCIES (SCREW UP) FALL PROTECTION, GET'S IT
400

What is LIMITED ARRESTING FORCE WHEN A WORKER WEARS A HARNESS?

¿Qué es la FUERZA DE DETENCIÓN LIMITADA CUANDO UN TRABAJADOR USA UN ARNÉS?

1800LBS


400

Where is the preferred anchor point located?


¿Dónde se encuentra el punto de anclaje preferido?


Shoulder height or above.


Altura de los hombros o superior.


400

When should a harness be inspected?

¿Cuándo se debe inspeccionar un arnés?


before every use


 de cada uso


400

HOW HIGH DOES A TOE BOARD NEED TO BE IF YOU HAVE MATERIAL STACKED UP 11" NEXT TO THE OPENNNG.

15"

400
REPLACE GUARD RAILS, CONTACT GC AND LET THEM KNOW YOU CAN'T WORK IN THESE CONDITONS. DON'T SAY START WORKING YOU WILL LOSE 100 POINTS
YOU ARE SETTING UP TO WORK AND THERE IS AN UNPROTECTED EDGE 4' TO YOUR LEFT, ANOTHER SUB LEFT THE GUARD RAILS DOWN, WHAT SHOULD YOU DO
500


What is BREAK IN ELEVATION THAT REQUIRES A LADDER OR STEPS

¿Qué es BREAK IN ELEVATION QUE REQUIERE UNA ESCALERA O ESCALONES?


19 inches


19 pulgadas


500

Anchors must be ____________ with the snap hook or carabineer.

Los anclajes deben ser ____ con el gancho de presión o el mosquetón.


Compatible 

500

HOW OFTEN SHOULD YOU INSPECT YOUR HARNESS

EVERYTIME YOU WEAR IT

500

HOW HIGH DO YOU HAVE TO BE TO NOT USE FALL PROTECTION

below 4 ft

500
YES, EVEN THOUGHT IT'S NOT AN OSHA REQUIREMENT IT IS A GREEN REQUIREMENT, OSHA COULD SITE GREEN UNDER GENERAL CONDITIONS FOR NOT FOLLOWING OUR OWN SAFETY PROGRAM
DO YOU HAVE TO TIE OFF IN A SCISSOR LIFT