What kind of input device would you install in a outdoor parking garage on a 10 foot ceiling to recall an elevator from the 3rd floor to the 1st floor?
A heat detector
What is the minimum and maximum height requirement for a pull station?
42 to 48 inches
If a person you are working with is severely hurt on a job who is the first person you should contact for assistance?
911
What is the most common Phillips bit size that is used in the electrical trade?
size 2
What is the minimum space required between the front of any electrical panel and any other object?
2 Foot
What is the updated part number for a heat detector on a NFS2-640?
FST-951
How far apart can a smoke detector be from the FACP?
30 feet
What is the minimum PPE requirement while working for ADS on an active job site?
-Ankle high boots, Hi-vis vest or shirt, safety glasses, and gloves.
What size screw is used on a standard 4" square electrical box?
8-32
When is it required to have a raceway through a firewall?
Always
What device would you use to activate an R10-E on an onyx system in an alarm situation?
FCM-1
Based on the NFPA-72 code is a smoke detector required on either side of a smoke door if the ceilings are 3 inches in height difference?
No
What is the highest leg step on a ladder that you are allowed to stand on?
The second from the top
When using multi-meter, what feature would be used for measuring the voltage on a SLC circuit?
The DC feature
If the load of a circuit is holding amperage can you recieve a back feed off the neutral wire?
Yes
On an XPS-C what terminals would the Hi-audio from a digital amp be landed on?
The PS terminals
When is a Heat detector required for an elevator to be shunted
When a sprinkler head in in the shaft or next to any elevator equipment
When is it required to use a harness on a ladder?
ABOVE 8 FOOT
When using a meter what does the "OL" abbreviation mean?
open line
What is the difference between a high voltage circuit and a low voltage circuit?
A DAA2-7525 is capable of providing how many speaker circuits?
4
Is a smoke detector required to activate a fire hat recall for an elevator inside the elevator shaft if there is a hydrophilic system in place and the elevator equipment is located in a separate mechanical room then the elevator shaft?
It is not explicitly addressed in the NFPA-72 so therefore it is recommended to contact the design engineer to facilitate the correct answer based on state requirement and the standard that they state.
What is the minimum DV level for ambient sound the for a fire alarm device in a hotel room?
15 db
When measuring a hard short across a 2-wire circuit, which feature on the multi-meter would you use to measure the hard short resistance?
The Ohms setting
Which of the three conductors in a 120v AC circuit is the grounded wire
The neutral