Precision Measurement
Lines on a ruler are called what?
What is Graduations
Safety Glasses should be worn _______
what is Always, The entire time you are in shop
Long Stringy chips should be removed with
What is A chip Hook/Pliers
A layout fluid that makes lines more easily visible
What is Dykem
Whats your favorite color
what is red, yellow, blue, green, orange, and black
This precision measuring tool has a dial face and can read outside diameters, inside diameters, and depth diameters.
What is Dial Calipers
Avoid using compressed air to clean chips from machine tools because
what is Flying chips may cause eye injuries.
Lathe size is determined by what
A layout tool with a sharp point. It is used to make straight, accurate layout lines.
What is a Scribe
This character quoted in this 2005 racing film "if your not first your last"
what is Ricky Bobby will farrel
This precision measuring tool only reads outside dimensions and is accurate within .0001
What should never be worn when working on machinery?
The worktable on a plain milling machine is capable of movements in ________ directions
What is three
What two angles can be layed out with a combination square?
what is 45 and 90 degrees
In this Movie a disabled dodgeball legend has a catch phrase "if you can dodge a wrench you can dodge a ball"
who is patches o hullanhan or rip torn or hank azaria
What is our tolerance when working in this shop?
what is +/_ .005
Oily rags and waste materials used in the Precision Machine laboratory should be placed or stored in an approved, closed, metal container to
What is prevent fire (Spontaneous Combustion)
Always stop a machine before making _______ and measurements.
What are adjustments
What two tasks can a divider be used to perform?
What is Layout of circles, and arcs
In this movie this character redoes school grades 1-12 to prove to his father that he can run Madison Hotels
What is Billy Madison
The computer on a milling machine and or engine lathe is also reffered to as what?
What is DRO (Direct Read Out)
A sharp edge on a part that is typically cleaned with a file or a whirly bird tool.
A draw bar Screws into what component that holds your cutting tool on a vertical milling machine
what is collet
What would the divider setting be for a 3/4" diameter hole?
What is 3/8"
In this classic this character States "these arent the droids your looking for"
who is Obi Wan Kenobi