Aircraft Drawings
What is adjacent to the title block or at the top right hand corner?
The two general types of fluid lines commonly used in aircraft plumbing.
What are metal tubing (rigid fuel lines) and flexible hose?
This person makes the final maintenance record entry after a 100-hour inspection is completed.
Who is the person approving for return to service?
The three states of matter.
What are solids, liquids, and gases?
When the external magnetizing force is removed, this happens to temporary magnets.
What is they rapidly lose magnetism?
The type of diagram a mechanic would use for troubleshooting.
What is a schematic diagram?
Do not exceed this percentage of flattening when bending metal tubing.
What is 75%?
The purpose of the ATA 100 System.
What is to standardize technical daya regardless of manufacturer?
ATA = Air Transport Association
The term used to describe the ratio of the amount of water vapor actually present in the atmosphere as compared to when the air is saturated with water vapor.
What is relative humidity?
The three basic elements of Ohm's law.
What are E (voltage), I (current), and R (resistance)?
The sum of the plus and minus allowance figures on aircraft blueprints.
What is tolerance?
This is how you can tell that a flexible hose has been installed in a twisted position.
What is by the identification stripe running along the hose length?
This person is responsible for determining that materials used in aircraft maintenance and repair are of the proper type and conform to the appropriate standards.
Who is the installing person or agency?
This causes an airplane wing to stall.
What is the separation of airflow across the top of the wing from the wing's upper surface?
The components of an electrical circuit.
What are electrical pressure, resistance, and conductors (in the form of aluminum or copper wires)?
The dimension allowable between parts.
What is clearance?
Name at least two synthetic materials commonly used in the manufacture of flexible hose.
What are (1) Buna-N, (2) neoprene, (3) butyl, (4) ethylene, (5) propylene diene rubber (EPDM), and (5) Teflon?
Wher e a mechanic may find an example of a 100-hour inspection maintenance and record entry.
What is 14 CFR 43.11?
The function of wing mounted vortex generators.
What is to delay or keep the airflow from separating from the upper surface of the wing during high speed flight?
The law relevant to Voltage Law
What is Kirchoff's Law?
The name of the list of materials and parts necessary for the fabrication or assembly of a component or system.
What is the bill of materials?
These are the parts of a military standard flareless-tube fitting.
What are a body, a sleeve, and a nut?
This regulation authorizes a certificated mechanic with an inspection authorization to approve or disapprove a major repair or major alteration.
What is 14 CFR 65.95?
This change occurs in the flow of air through the main rotor system of a helicopter when transitioning from normal powered flight to autorotation.
What is it is reversed?
The amount of voltage most aircraft systems require for special equipment.
What is most 24-volt aircraft systems need 400 cycles of AC current?