Fast
The method of manufacturing shears whereby molten steel is poured into a mold and cooled is called ___________ .
casting
The amount of pressure applied when combing and holding a subsection is called _________________.
tension
The guideline located at the perimeter of the cut is called the ___________guideline.
outer line
Combing hair away from its natural falling position, rather than straight out from the head, toward a guideline, is called ______________.
overdirection
The widest area of the head, starting at the temples and ending at the bottom of the crown, is known as the ______________.
parietal ridge
When elevating the hair at 90 degrees or higher you are ____________.
removing weight
All haircuts are composed of lines, sections, and____________ .
angles
The technique of holding the scissor with the ring and little fingers of the opposite hand while the hair is combed is called ___________ .
palming the shear
Haircutting serves as the for all other hair designs.
foundation
The highest point of the head is known as the________________.
apex
What guidelines are used when creating layered or graduated haircuts?
Traveling guide
The direction in which the hair grows form the scalp is called the ____________.
growth pattern
The two basic lines used in haircutting are straight and _____________.
curved
What implement is used to create short tapers, fades, and flat tops?
Clipper
A zero-elevation cut is also known as a _____________cut.
no elevation
The triangular section of hair that begins at the apex and ends at the front corners of the head is known as the ____________.
bang area
What technique is necessary to help control the hair and produce a more uniform cut?
Sectioning
The angle at which the fingers are held when cutting the line that creates the end shape is known as the_________ .
cutting line
The _________________of the hair will determine the size of the subsection when cutting.
density
A technique of using diagonal lines by cutting hair ends with a slight increase or decrease in length is called _____________.
beveling
What implement is used to create clean lines around the perimeter of a short taper?
Trimmers
The angle or degree at which a subsection of hair is held or elevated from the head when cutting is called ________.
elevation
What subsection of hair determines the length that the hair will be cut?
Guideline
The area of the head between the apex and the back of the parietal ridge is known as the _____________.
crown
The primary implement used to remove bulk from the hair is known as the texturizing shear or__________.
thinning shear