Lingo
In hair design, the two categories of surface texture are known as what?
Unactivated and Activated
Rain, humidity, and shampooing will cause thermally styled hair to react in what way?
Hair returns to its original shape
Before brushing or combing the hair after a thermal procedure, make sure the hair is ______ .
Down the hairstrand from the scalp to the ends (with the direction of the hair cuticle)
Which bonds in the hair are weakened or broken by water or thermal heat?
Hydrogen bonds
Using a hand-held dryer while simultaneously using the fingers to style the hair is an example of what?
Thermal designing
A section of hair that forms a pincurl is commonly described in three parts as the base, stem (arc), and what?
Circle
The size of the curl will be determined by the what?
Diameter of the tool or roller
During hair pressing, fine hair requires less what?
What determines the length of the base?
The length of the tool being used to create the curl
What is the area called on which a roller, thermal iron, or round brush is placed?
Base
What part of a curl is positioned around the roller, thermal iron, or round brush?
Circle
The base control that results in maximum volume and maximum base strength is called what?
On base (full base)
Loss of hair elasticity or split ends may be caused by what?
Excessive blow drying or thermal styling
Hair design is a temporary change in what?
Which base size means the same diameter of the tool?
1x
A long, slow wave would be an example of what type of texture pattern?
A slow-speed texture pattern
Hair that is held at a 45o angle above the center of the base and rolled to sit in the upper portion of the base, but not on or above the parting can be described as what?
Overdirected (volume base)
The pressing comb is used ONLY on ______.
Balance, whether symmetrical or asymmetrical, plays a integral part in the dynamics of a design and must be analyzed how?
From all angles
What term refers to carving out shapes in the proper size and proportion to establish the lines of the design?
Scale
S - Shaped
Holding the hair at 90o from the center of the base and having the tool sit half-off and half-on the bottom parting results in which type of base control?
Half-off base (half base)
Crimping irons create which type of texture in the hair?
Angular
What are the five wet-setting procedures?
(1) Distribute
(2) Mold
(3) Scale
(4) Part
(5) Apply