Show:
A
B
C
D
E
100
The part of the head that is found by placing a comb flat on the side of the head is the:
Parietal Ridge
100
The two basic lines used in haircutting are:
Straight and Curved
100
The straight lines used to remove weight and create graduated or layered haircuts are:
Vertical
100
Elevation occurs when you lift any section of hair above:
0-degrees
100
When cutting curly hair, you will usually need to:
Use less elevation and leave the hair longer.
200
The guideline where a small slice of a previous subsection is moved to the next position and becomes the new guideline is a:
Traveling Guide
200
A guideline used in a blunt, one-length haircut, or used in overdirection to create a length or weight increase is a(n):
Stationary Guide
200
The conversation where the practitioner offers professional advice and suggestions to a client is called the:
Client Consultation
200
The thickness or diameter of each hair strand is referred to as hair:
Texture
200
The amount of movement in the hair strand is referred to as the:
Wave Pattern
300
Which type of comb is mainly used to section and subsection the hair?
Tail Comb
300
Which tool is mainly used to remove excess or unwanted hair at the neckline and around the ears?
Trimmers
300
How often must you disinfect your shears?
After each guest.
300
When palming the shears, you hold the comb between the:
Thumb, index finger, and middle finger.
300
When cutting curly hair, you should NOT:
Use maximum tension.
400
When cutting with a vertical or diagonal cutting line, the best way to maintain control of the subsection is to cut:
Palm-to-Palm
400
When cutting below your fingers, you should not cut past:
The second knuckle.
400
A one-length haircut where all the hair comes to one hanging length is also known as a:
Blunt Cut
400
A basic haircut where the hair is cut at a 180-degree angle is the:
Long-layered cut
400
If a client's hair is thin with a medium texture, which type of cut should you use?
Graduated Cut
500
The process of removing excess bulk without shortening hair length is:
Texturizing
500
A texturizing technique performed on the ends of hair using the tips of the shears to remove bulk is:
Point-cutting.
500
Which type of hair will appear to graduate the most?
Coarse, curly hair.
500
When using the razor-over-comb method, in which direction should the teeth of the comb be facing as you cut?
Down.
500
Which tools can be used for trimming facial hair?
Clippers, scissors, or trimmers.