Woodworking
Architecture
Measurement
Safety
Engineering Design Process
100

This tool is used to cut or "rip" wood along the grain

Tablesaw

100

What is the difference between a full bath and a half bath?

A full bath includes a shower or tub

100

A typical American tape measure is divided into what scale?

Sixteenths 

100

What are two examples of PPE or personal protective equipment?

Glasses, ear protections, gloves, masks

100

The first design you build is known as what?

Prototype

200

This tool is used to cut wood across the grain

Chop Saw

200

Drawing floor plans by hand is known as what?

Drafting

200

The United States uses what system of measurement?

Imperial 

200

When cutting a board that is cupped (not flat), on the table saw, should the board being smiling or frowning at you?

Smiling

200

Something that would limit completing your design

Constraint

300

What is another name for the chop saw?

Miter Saw

300

What three things are required to legally refer to a room as a bedroom?

Egress window, 70+square feet, closet

300

Square footage is a measure of what?

Area

300

In Mr. Bopp's experience, what is the most common cause of shop accidents?

Rushing!

300

Something that you must include in your design

Criteria

400

This automated manufacturing process uses computer-controlled machines to cut and shape materials based on digital designs.

CNC (Computer Numerical Controlled) Router

400

The set of rules and regulations builders in the U.S use.

Building Codes

400

Two lines below the 1" mark on the sixteenths scale is what fraction? (LCD)

7/8"

400

In the wood shop, it's important to avoid wearing these types of clothing that could get caught in moving machinery.

Loose or baggy clothes, drawstrings or dangling jewelry

400

What is the purpose of building a model or initial design?

To test it!

500

Choosing straight boards, keeping your board on the fence, using appropriate guards, and not pushing into pressure area all ways to prevent this

Kickback

500

A roof pitch of 12/12 has what angle/slope roof?

45 degrees

500

Eight lines in from zero using the 32nd scale is what fraction? (LCD)

1/4"

500

What are two ways that can affect your safety MINDSET in a shop environment?

Hunger, emotions, rushing, dehydration,

500

The purpose of the engineering design process is what?

Innovate, to create the best solution to the problem at hand