Components
Compressor operation is controlled by the:
What is Contactors? C1 & C2
On initial motor starts up, you will be able to read (-----) type of reading with your clamp on your electrical meter.
What is Full Load Amperage?
What is Indoor Fan Relay?
Capacitors are rated by
What is Micro-farads?
The compressor and the condenswer fan motor are wired in (-----) with each other.
What is Parallel?
A schematic diagram shows the components in this type of position
What is de-energized
A typical open electric motor is cooled by.
What is airflow through the motor?
The High-pressure switch and low-pressure switch are both wired in which way with what switching device.
What Is Wired in series with the Contactor?
The Compressor, Condenser fan motor and evaporator fan motor are operating, The voltage measured between terminal R and G on the thermostat will read.
What is O Volts VAC?
The Transformer and the indoor fan motor are wired in (------) with each other.
What is Parallel?
A Standing Pilot is known as a (---).
Continuous Flame.
This Type of motor provides and soft start and gradually ramps up to full speed.
What is An ECM motor? (Electronic commutated Motor.)
Wire size is determined by.
What is Amperage?
The Compressor, Condenser fan motor and evaporator fan motor are operating, The voltage measured between terminal Y and C on the thermostat will read.
What is 24 Volts?
A Device used to prove a quality Flame in an A/C System.
What is a Thermocouple? AKA Flame sensor