What in the?
Tech A says, A TXV is not TXV-ing(adjusting flow). It will affect both high and low sides.
Tech B says, A TXV is not TXV-ing(adjusting flow) the customer concern will be poor A/C performance.
What is both are correct?
What is the job of the condenser
What is Change liquid to vapor.
How many fans can some vehicles have equipped
What is 1 or 2 ?
Tech A says Condensers don't have to be cleaned of debris.
Tech B says Consensers are found in the low side of the system.
What is Both are wrong.
The___ controls the ground side of the compressor clutch?
What is the Pressure-Cycling switch
Tech A says, That a visual inspections involves checking for metalic dust on the pulley.
Tech B says, When doing a visual. Inspect the wiring for chaffing and other types of damage
What is both are correct.
How is the clutch controlled in a switched controlled system.
R-134a contains Cholrine
What is False?
Tech A says Evaporators that are cloged and cannot be flushed. You don't have to replace it.
Tech B says Refrigerant has to absorb heat in order to change from a Liquid to a Vapor?
What is Both are wrong.
Tech A says, It's ok to replace the clutch if the compressor is fine.
Tech B says, you need a special tool called a spanner wrench to remove the clutch.
Who is both?
After installing the evaporator. You HAVE TO ALIGN the Upper half of the plenum to the ____?
What is the Lower Half of the Plenum?
What does mold smell like?
R-12 is sold in a soild white container?
What is True?
To diagnose a TXV. You should measure the Inlet and Outlet of the Evaporator.
What is True?
Where is the H-Valve located?
Where is on the inlet and outlet of the Evaporator?
A Clamping Diode allows voltage spikes to go back to the Hvac module?
What is False?
What side or sides are Pressure Cycling Switch found ?
F.O.T.s can have a remote sensing bulb.
What is False?
What is the name of the tool used to correct Condenser Fin damage
When it is full of debris?
A/c uses a mechanical or electrical fan to remove heat from the condenser?
What is true?
Some compressors require the use of a clutch hub installer to adjust the air gaps between the compressor clutch hub and the compressor____?
What is the pulley?
What Principal does the electronic Compressor Clutch use to engage the compressor?
What is Electro-magnetism?
The T.X.V.s remote sensing bulb has to make good contact with the Outlet of the Evaporator.
What is True.
How many OHMS is a good Field coil resistance