Joints
Terminals
Clip/Clip
Picture This 1
Safety
100
A solder joint exhibiting poor wetting and insufficient heat. Usually appears frosty and granular
Cold solder joint
100
A tie point for making electrical connections.
Terminal
100
This tool is used to form hooks and bends in wire. Prevents damage to wire
Round nose pliers
100
This condition represents a build up of solder between parts, part leads, and/or base materials.
Bridge
100
When leaving your work station for break what devices should be turned off?
Solder iron and thermal strippers
200
A connection that has inclusions, flux residues, cotton fibers, foreign matter, dirt, on or embedded in the surface.
Contaminated Joint
200
A terminal formed in the shape of a hook.
Hook terminal
200
Which tools shall not impart stress to the component bodies or seals.
Bending tools
200
This picture shows a connection that has inclusions, flux residues, cotton fibers, foreign matter, dirt, on or embedded in the surface
Contaminated joint
200
This tool attached to the solder iron is used to remove and replace the tip.
flap
300
A joint which shows evidence of cracking within the solder.
Fractured solder joint
300
A round post type grooved stud around which conductors are fastened before soldering.
Turret Terminal
300
These tools should not be used to form hooks or bends in wire. Surface may cause nicks and/or cuts in wire
Needle nose pliers
300
This condition shows a solder joint exhibiting poor wetting and insufficient heat. Usually appears frosty and granular.
Cold solder joint
300
Which direction when trimming leads should the operator position the lead?
Down toward the table.
400
A solder joint containing holes
Porous Solder Joint
400
A terminal with a hole through which wires are routed before soldering.
Eyelet terminal
400
These tools are utilized to remove insulation from stranded and solid conductor wires shall be of a type that can be regulated to provide the required temperature.
Thermal strippers
400
This type of terminal shows a slot or split in which wires are put before soldering.
Bifurcated terminal
400
Which PPE is used during soldering? Must identify at least one correct PPE
Safety googles, gloves
500
A solder joint which contains trapped flux.
Rosin Solder Joint
500
A device with good heat dissipation attributes. Conducts heat away from an object.
Heat sink/Thermal Shunt
500
These tools are used for wipe-cleaning the soldering tip shall be fine-texture, low-sulphur, synthetic sponge and shall be kept clean and moistened with water.
Cellulose sponge pads
500
This surface condition is where the entire inner surface is not visible.
Blow hole
500
Which bin should solder wires be disposed in?
Solder waste bin