Planer
How many boards can be fed safely through the planer at on time?
1
If the blade breaks on the band saw, shut off the power and..
move away quickly
What type of drill press chuck should be used with a straight shank twist drill.
Jacobs chuck
The jointer has a cutter head which holds __ knives?
3
Which side of stock should the stock be cut on?
left side.
Industrial quality protective equipment should be worn for protection?
Ears
If too much cutting pressure has to be applied to make a cut, the blade
is dull
When operating the drill press, what should be done with long hair?
Tie it back close to your head and keep your head away from moving parts
Always joint __ the grain?
Should you clamp the stock when using the miter saw?
yes.
The purpose of the off-bearer when using the planer it to...
support, pull, and move with the stock as it comes through the planer
The danger zone for the band saw is..
To the right of the operators position
If the stock being drilled begins to revolve, you should
Turn off the drill press and free the stock
An 6 inch jointer has knives that are ___ long?
6
How far away should your hand be when cutting?
6"
When leaving the planer work area?
turn the machine off and wait until all moving parts stop before leaving the planer work area.
When you give work your individual attention you..
which is not a safe way to secure stock while it is being drilled?
Hold it firmly by hand, securely on the drill press table
Always use the _____ when jointing a face?
push block
Which side of the miter saw is unsafe while in use?
the right side.
Lumber should be fed into the planer...
against the grain
The band saw is designed for cutting __ and __. (two answers)
curves and re-sawing
Which should be done while drilling stock with the drill press.
Maintain enough feed pressure to keep the bit cutting at all times.
When using the jointer you should?
Make as many cuts as needed?
1/8" inch