some questions
The maximum length of the exhaust duct shall be _____ feet from the connection to the transition duct from the dryer to the outlet terminal
35'
M1502.4.2.1
The unlisted appliances shall be based upon approved of _____________ ______________.
Manufacturing Companies that built the appliance
G2408.1
Vents for natural draft appliances shall terminate not less than _____ feet above the highest connect appliance outlet
5 G2427.6.4
Natural draft gas vents serving wall furnaces shall terminate at an elevation not less than ______
Feet above the bottom of the furnace.
12
G2427.6.4
true or false sharks can blink
true
Connectors penetration in walls for oil-fired appliances listed and labeled ___ ___ vents
L Type
M1803.2
A connector shall not be smaller that the flue collar of the appliance
True or False
true
M1803.3.3
What is a conductor installed to electrically connect metal parts to the grounding electrode system?
Bonding Jumper
Pg665
What freeze protection is needed where the temperature is greater than 32°F (0°C) for Solar Heat
Not Required
M2301.2.6
true or false Crocodiles can stick out there tounges
false
When applying for a permit who is required to sign the Permit
Applicant or Authorized agent R105.3
Heat transfer fluids shall be in accordance with ________. The flash point of the heat transfer fluids utilized in solar.
SRCC 300
M2301.4
True or False -A building with four stories or less shall apply to the International Residential Building Code.
False
R101.2
In combustible construction, fire blocking shall be provided to cut off both vertical and horizontal concealed draft openings and to form an effective fire barrier between stories, and between a top story and the roof space. which applies
Vertically at the ceilings and floors
R302.11
true or false fruit loops are all the same flavor
true
)Where piping will be concealed within light-frame construction assemblies, the piping shall be protected against penetration by fasteners, except for ______ _______ and ______ _______.
Cast Iron, Galvanized Steel
P2603.2.1
Where there is a conflict between a general requirement and a specific requirement, the ________
_________ shall be applicable
Specific requirements shall be applicable
R102.1
True or False -Access shall be required for ducts, piping, or other components approved for concealment.
False
M1305.1.4
Electric heat pumps shall be listed and labeled in accordance with UL/CSA/ANCE 60335-2-40
U.L 1995
M1403.1
what country does McDonalds serve spaghetti om their menu
Philippines
True or False -Chimney flues shall be smaller in area than that of the area of the connector from the appliance to promote the convection of flue gas to be exhausted
False
M1803.3.3
Where piping is located outside of a framing member and is located 1 ½ inches (38mm) from the nearest edge of the face of framing which the membrane will be attached, the piping shall be protected that cover the width and ________ of the piping
Length
M1308.2.2
The minimum required combustion air volume shall be _____ cubic foot/feet 1000 Btu/h of the appliance input rating
50
G2407.5.1
For Combustion Air the minimum dimension of air openings shall be not less that _____ inches
3"
G2407.6
what president had a pet alligator
Double jeopardy
John quincy adams