Safety
Tools
Wood walls
Rafters
Lumber types and sizes
100
Cleaning up spills immediately helps to prevent which one of the following types of accident?
What are Slips?
100
A tool that name is defined by its blade.
What is a circular saw?
100
The piece of lumber that runs from the bottom plate to the top plate.
What is a stud?
100
The unit rafter length is calculated using the theorem of Pythagoras (
).
What is True?
100
This lumber is one of the most used types of lumber. This tree grows fast and is an evergreen.
What is Pine or S.P.F.?
200
It is easy to become careless when doing _____________________ work.
What is Repetitive?
200
Which of the following clamps consists of a long metal bar with plates or jaws that press against a material and are then tightened by either a powerful spring or a screw shaft handle?
What is a bar clamp?
200
This is the piece of lumber that supports the header on both sides of the opening.
What is the Trimmer Studs?
200
This is the total distance measured from the outside wall to the outside wall.
What is the Span?
200
The nominal size of a 2"x4".
What is 1-1/2" x 3-1/2"?
300
To minimize the blade exposure on a portable circular saw, the blade depth should be set _____________________ below the material to be cut.
What is 1/8" to 1/2"?
300
A clamp that consists of pipe with plates or jaws that press against a material and that are tightened by a screw shaft handle is called a _____________________ ______________________.
What is a pipe clamp?
300
These are the components that all the wall studs attach to.
What are the plates, top and bottom?
300
The ridge deduction is equal to which of the following?
What is half the ridge thickness?
300
This material is made up of layers of wood pressed together to make a 4'x8' sheet.
What is plywood?
400
Name 4 types of PPE.
What is safety glasses, hard hats, gloves, lanyard (fall protection), boots, visibility vests, face shield, etc.?
400
This tool is primarily used for fine finish work and cutting miters.
What is a Miter Saw?
400
This component is used to span the gaps of an opening and distribute weight.
What is a header?
400
The portion of the rafter that extends beyond the outside edge of the exterior wall is called the rafter _____________________.
What is the tail?
400
This material is made of flat cut-up pieces of a pine tree. This process uses all of the log. The pieces are glued and compressed.
What is OSB?
500
This is how many steps you should stay down from a 10' Step Ladder.
What is 2 steps?
500
Tool used primarily for making rip cuts.
What is a table saw?
500
This build up of wood is placed in a wall and will except a perpendicular wall. This gives nailing for the perpendicular wall and nailing for drywall on either side of this component.
What is a Partition Stud?
500
Adding the line length to the overhang equals which of the following?
What is the Total Rafter Length?
500
The nominal size of a 2"x12".
What is 1-1/2" x 11-1/4"?