Device Basics
How often does Stryker recommend users perform a shift check?
Daily
How many full waveforms can be viewed on screen at once?
5
What is the maximum amount of energy you can deliver on the LP35?
360J
You notice a flat line or dashed line in the ECG channel, what is the first thing you check?
Lead connection/Which lead is selected to be in ECG channel
Which channel/vital can be used as real time physiological feedback during compressions?
EtCO2
How much monitoring time will one fully charged battery give you?
About 4.5 hours
True or False: You shouldn't have the BP cuff on a patient's arm when powering the device on.
True
What mode does the device pace in as a default?
Demand Mode
Your printer isn't printing. What are two things to check?
1. Make sure there is paper
2. Paper is loaded correctly (beard not mullet)
3. 1 inch of paper out when the printer is closed
4. Printer cable has a secure connection
What is the purpose of CPRinsight?
Minimize pauses and improve compression fraction
True or False: The device cannot be used on a patient if the readiness indicator is blinking.
False
If you have a 4 lead ECG cable and pads on a patient, what will the device default the ECG channel to read through?
Pads
True or False: The provider will see the underlying rhythm in the ECG channel when CPRinsight is turned on.
False
"SpO2 Sensor Off Patient" message appears on the screen, what are the 3 ways to address this?
1. Put sensor back on patient
2. Reset channel by unplugging and replugging
3. Remove trunk cable and then remove channel from the screen
When events are recorded in the LP35, they capture a rhythm strip that is how long?
8 seconds (3 pre and 5 post)
Name one reason why the readiness indicator may be blinking
1. One or more batteries are at or below the Low battery level
2. Unrecognized battery of battery fault detected
3. No batteries or only one battery installed
4. Auto test failed
5. User test failed (Shift check or Monthly check)
6. Therapy cable or internal paddles not connected during auto test or shutdown
7. Test load connected
Which channel will show you the patient's respiratory rate?
EtCO2
True or False: You can cardiovert with only pads on the patient.
True
True or False: You can trend vitals while therapies are ongoing.
False
How many times will the device attempt to transmit before officially failing?
3 times
Where on the device is the EtCO2 exhaust port located?
If you are monitoring a pediatric or neonate patient, which setting should you change on the monitor to automatically adjust alarm limits and initial cuff pressure and where is it located?
Patient type setting under "Alarms"
What happens when a provider hits "pause" during pacing?
The rate drops to 25% of the set rate to reveal the patients own rhythm.
My readiness indicator is blinking...where on the device do I go to see the exact reason why?
Under the "System" menu, which you can get to by clicking on the battery icons in the header
How long does the device store patient cases in the archives?
30 days