General Lab Safety
The student should notify the instructor immediately in case of _________.
Accident, Injury, or Defective Tools
Where should the saw arm and blade be positioned when cutting is complete and the operator is leaving the work zone?
Reset to 90 degrees on all gauges and left up with all guards intact and the trigger off
Relief cuts are cuts made with the band saw. They __________.
Prevent the Blade From Binding
When operating the drill press, what should be done with long hair?
Tied Back
If a fire happens to break out on the sander, try to unplug it but don’t get hurt in the process. Make sure you _____________ ____________ and then notify the instructor.
Back Away
At the end of class, the laboratory should be ___________.
Cleaned With All Tools Returned
The purpose of a trial cut before making the actual cut with the motorized miter saw is to ____________
See if the blade is positioned and cutting correctly
The best time to remove scrap material from the band saw is ___________.
When the Saw Stops
Which item(s) of protective equipment is/are absolutely necessary when operating the drill press?
Safety Glasses
When sanding many parts, like in a production run, it is a good idea to ___________ off the sander periodically to reduce the chance of a fire from the fine dust.
Clean
Students should never ________ while working in the laboratory.
Shout
Besides safety glasses and closed toed shoes, what personal protective equipment should be worn when operating the motorized miter saw?
Hearing Protection
Splitting a thick piece of wood into several thin pieces is called ___________________.
Re-sawing
Before turning on the drill press the operator should _________. (3 Things)
Tighten Drill Press Table Clamp, Clamp Work, Remove Chuck Key
Keep hands and fingers at least _____________________ inches from all moving parts on any machine.
Four
The Z-87.1 logo and manufacturing emblem on shop safety glasses tells the users specifically that the glasses are:
Rated for our shop environment (Impact and Shatter Resistent)
When both the turn base is rotated and the arm is tilted the cut made is a ____________
Compound Miter
The blade on the band saw should be installed with the teeth pointing _________.
Downward
Stock chips and curls should be removed from the drill press _________.
Use the machine's ___________________ to hold the stock while sanding. Do not hold it freely in your hands.
Table
Approved safety glasses can be identified by ___________.
The Z 87.1 Logo / Manufacturer's Emblem
What special protection must be observed when using the motorized miter saw outside?
Ground Fault Circuit Interrupter (GCFI)
If it is necessary to back the blade out of a cut, __________.
Turn Off The Power and Free The Blade
What type of drill press chuck should be used with a straight shank twist drill?
Jacob's Chuck
There is danger of kickback if you use the __________ spinning side of the disc
Upward