PPE
The ____________ must pay for PPE?
The Employer
How often do ladders need to be inspected?
Prior to each use
The item that states a chemical, health hazards associated with that chemical, the PPE requirement when handling a chemical and has pictograms is called a ____________.
Safety Data Sheet?
This standard piece of safety gear protects your eyes and face from intense radiation, sparks, and debris
What is a welding helmet (or hood)?
This critical safety feature must always remain attached to the grinder to redirect flying sparks and fragments away from the user
What is the guard?
___________ is the first step in the hierarchy of controls, while ___________ is the last.
Elimination and PPE
What does GFCI stand for?
Ground-Fault Circuit Interrupters?
Three elements needed to cause a fire are ____________, _______ & _________.
Heat, oxygen, and fuel?
You must always wear these under your welding helmet to protect your eyes when your shield is flipped up
What are safety glasses?
This catastrophic event can happen mid-operation if you use a grinding stone on the wrong type of metal or apply excessive side pressure.
What is a wheel explosion (or shattering)?
This is how often PPE should be inspected!
Before Each Use
Before the operation of any equipment including scissor lifts, THIS must be completed.
Equipment Inspection?
How old do you have to be to operate a forklift, regardless of training?
18 years old?
The specific American national standard rating that must be stamped on the frames of your shop safety glasses
What is ANSI Z87.1?
You must check this parameter on a new grinding disc to ensure it is rated higher than the RPM rating printed on the grinder itself.
What is the maximum operating speed (RPM)
This is the height at which fall protection is required in general industry.
4 Feet
What does the double square symbol on electrical tools signify?
Double insulated?
This acronym is commonly used to remind employees how to use a fire extinguisher.
P.A.S.S.?
This type of fabric should never be worn while welding or grinding because it melts directly to your skin when hit by hot sparks.
What are synthetic fabrics (like polyester, nylon, or rayon)?
The type of grinders allowed in the Manufacturing center.
What are Dewalt corded grinders
This is the ANSI cut level that all gloves must meet according to CWC.
Cut level 4
This is the height at which fall protection is required on a ladder with CWC.
10 Feet?
This is the hazardous metal particulate produced by welding carbon pipe
What is Manganese?
This piece of full-face gear is required in addition to safety glasses specifically when operating a handheld angle grinder.
What is a face shield?
This is the rule you should follow regarding any piece of metal in a welding shop, regardless of how long it has been sitting out.
What is assuming it is hot (and sharp)?