Drill Press
What piece of safety equipment NEEDS to be worn when using this machine?
Safety Googles
How many hands should grasp the stock?
Hold the stock freely in your hand. True or False?
False
Hearing protection should be worn when using this machine. True or False?
True
Horseplay is prohibited. True of False?
True
To prevent seizing...
The bit needs lubrication.
There is little danger of _________________ on the band saw.
Kickback
Once you have finished using this machine wait until all moving parts have __________ before leaving the machine.
Stopped
When is it safe to remove wood scraps from the cutting zone?
While the saw is off and the hand is not on the On/Off trigger.
The “yellow” color coding system refers to......
Caution
To select the proper drill bit, one should check.....
Size, sharpness and type of shank.
If the blade breaks on the band saw, shut off the power and.......
Remove your work.
There is danger of kickback if you use the __________ spinning side of the disc.
Upward
How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw?
Slowly
A student is permitted to leave the laboratory only....
With the instructor’s permission.
What type of drill press chuck should be used with a straight shank twist drill?
Jacobs chuck
Avoid ____________ of a cut.
Backing out
When sanding many parts, like in a production run, it is a good idea to ___________ off the sander periodically to reduce the chance of a fire from the fine dust.
Clean
How must the saw blade be held after the cut is finished and before the blade stops rotating?
In the down position.
What is a unit of measurement that involved an arm to figure it out?
Cubit
After a drilling operation is completed what potential hazard should the operator be alert to__________.
Sharp edges and burrs around the hole.
If too much cutting pressure has to be applied to make a cut, the blade...........
Becomes dull
Keep hands and fingers at least _____________________ inches from all moving parts on any machine.
4
Hands or fingers should never come closer than _____ inches to the rotating blade when operating the motorized miter saw
6
Approved safety glasses can be identified by ___________.
The Z 87.1 logo and manufacturer’s emblem.