Drill Press
Belt-Disc sander
Scroll saw
palm sanders
Etc
100

You must always remove this T-shaped tool from the chuck before turning on the power, or it will become a dangerous flying projectile

 chuck key

100

You must always wear one piece of personal protective equipment  before operating a belt-disc sander.

 Safety glasses 

100

You must always wear these over your eyes before turning on the scroll saw

 safety glasses 

100

You should always do this to a corded palm sander before changing the sandpaper or making any adjustments

 unplug it

100

what should you always put on when you enter the shop

 safety glasses

200

Unlike many shop tools, you should never wear these on your hands while operating a drill press because they can get caught in the spinning bit.

gloves

200

You must always keep your fingers at least this many inches away from the moving belt or disc

 2 inches

200

You should never make blade changes or table adjustments while the power is in this state

 turned on (or running)

200

Unlike a round random-orbit sander, the square or rectangular base pad of a palm sander allows it to easily get into these tight architectural spots.

 corners (or inside corners)

200

You should open this valve at the bottom of the tank after every use to prevent rust from building up inside.

 the drain valve

300

Instead of using your bare hands or compressed air, you should always use this tool to sweep metal shavings and wood chips off the table.

 brush

300

Before changing a torn sanding belt or adjusting the belt tracking, you must always perform this safety step with the power cord

 disconnect/unplug the machine from the electrical plug

300

Instead of using your bare hands to clear sawdust and small scraps near the blade, use one of these two tools

 a table brush

300

The general rule of thumb for how much downward hand pressure you should apply when letting a palm sander do its job.

 none

300

Commonly used for picture frames and baseboards, this is the standard angle setting required to make a 90-degree corner from two pieces of wood

 45 degrees

400

If a drill bit binds or gets stuck in your work piece, this is the very first action you should take.

 turning off the machine

400

Reaching across the spinning face of this part of the sander to turn the machine off can result in a serious cut on your hand or arm

 the sanding disc

400

Keep your fingers out of this imaginary line directly in front of the blade while feeding wood

 line of cut (or cutting line)

400

To prevent sawdust from flying into the air, many modern palm sanders feature tiny holes in the base pad that connect to this removable rear attachment.

 a dust bag

400

Unlike a standard miter saw that only pivots left and right, this type of miter saw has a blade that also tilts to cut angles across the thickness of a board.

 compound miter saw

500

Your hands should maintain at least this many inches of clearance from a spinning drill bit at all times.

 4 inches or 6 

500

On a standard counterclockwise-rotating sanding disc, you must only sand on this side of the face to prevent the piece from kicking or flying upward

 the down-stroke side (or center-to-left side)

500

If a blade snaps while you are cutting, this is the very first thing you should do.

 turn off the machine (wait for it to stop)

500

This rubberized, cushioned layer sits between the metal base plate and the sandpaper to absorb vibration and help the sander conform slightly to surfaces

 platen

500

This dangerous phenomenon happens when the wood pinches the spinning blade, violently throwing the workpiece back toward the operator.

 kickback