Reference Points
Surfaces on the head where it changes, such as ears, jawline, and occipital bone are referred to as ______.
Reference Points
The triangular section that begins at the apex and ends at the front corners
Bang area
Which type of shear adds increased blending?
Texturizing
These 3 countries are responsible to manufacturing shears
Japan, Germany, USA
The hand position that is most often used when cutting uniform or increasing layers is ____________
over fingers
Reference points in a haircut are used to establish ______.
Design lines
The space between two lines or surfaces that intersect at a given point is a(n) ____________.
angle
Electric or battery-operated tools that cut the hair by using two moving blades held in place by a metal plate with teeth are ______________.
Clippers
If blade tension is too ______________, it will allow shears to fold the hair.
loose
The hand position for cutting vertical or diagonal cutting lines.
Palm to palm
Achieving balance in a design is accomplished by understanding the head shape and ______.
Reference Points
The uniform working areas used for control during haircutting are called ______.
Sections
Shears that are designed to remove hair, with larger teeth set further apart.
Notching shears
The Ideal rockwell hardness of a shear
56-57
The visual line in a haircut where the ends of the hair hang together
Weight line
The part of the head that is found by placing a comb flat on the side of the head is the _______.
Parietal ridge
Haircutting lines that are parallel to the floor
Horizontal lines
Comb used for close tapers
Barber comb
Before purchasing ____, the stylist should analyze the cost of the shears, determine how many pairs are needed, and ask about the service agreement.
Shears
A basic haircut where the hair is cut at a 180-degree angle is the ________________
Long-layered cut
The highest point of the head is the _____.
Apex
If you want the hair to be longer toward the front on a layered haircut, overdirect the sections the sections to a stationary guide at the ______.
Back of the ears
This comb is used to detangle hair
Wide tooth comb
When a shear is fitted properly, the thumb hole will rest at or slightly over the ______.
Cuticle of the thumb
Technique used to check for haircut precision
Cross checking