MSHA's rule on when you must have fall protection.
What is "When you are in danger of falling"?
A separate path for electricity to follow, so it won't just go through you.
What is a ground?
Devices placed on either side of wheels or tracks of mobile equipment to prevent them from accidental movement.
What are Chocks?
This is needed before entering any confined space.
What is a confined space permit.
Abbreviated SDS
What is a Safety Data Sheet?
5000 lbs OR twice the expected loading in an engineered system
What is the load rating of an anchor point?
What does GFCI stand for?
Ground Fault Circuit Interrupter
Is done before operating any piece of mobile equipment on a shift.
What is a pre-operational inspection?
The minimum oxygen level before entering a confined space.
What is 19.5 %
What does NRR Stand for?
Noise Reduction Rating
A standard railing consists of a top rail, intermediate rail, and shall have a vertical height of ________ inches from the upper surface of the top rail to the floor.
What is a 42
The measure of electrical resistance.
What is an Ohm?
Areas where operators cannot see when seated in the cab.
What are Blind Spots?
The maximum oxygen level before entering a confined space.
What is 23.5 %.
What is Holt Mine ID Number?
CX2
A automatic device that limits the fall to less than 2 feet.
What is a Self-retracting lanyard?
Who may remove the lock from the machine?
Who is the person who closed the lock.
The proper procedure for carrying a load on a ramp with a forklift.
What is "load on the uphill side"?
What are the 3 elements for the Fire Triangle?(Fire Tetrahedron)
Oxygen, Fuel , Heat, (Chain Reaction)
How long does HOLT have to contact MSHA in the event of a fatality?
15 min.
How often shall full body harnesses be inspected?
What is before each use.
What is the WORST thing you can do if you contact a power line?
DO NOT GET OUT!
When is Forklift training required at HOLT?
BEFORE an employee can operate
Who MUST approve a Confined Space Mine Permit?
Supervisor through a Safety Rep Approval.
How tall must the berm be on a Mine Haul road?
1/2 height of larget tire using road.