Basic Lathe
This part of the lathe moves across the bedways, and is often used in parting and facing
What is the "Cross slide?"
This component grabs the lead screw to follow a thread
What is the "Half-Nut?"
The bridgeport universal mill uses this type of collet.
What is "R8?"
This person is responsible for scheduling and assigning maintenance, and is directly in charge of the craftsman
Who is the "Workcenter Supervisor"
This procedure uses Prussian blue to visually show contact points in a globe valve.
What is "spotting-in"
A gap lathe earns its name from this removable component
What is the "removable section of the bed?"
This pocket-sized tool can help you line up the threading cutter perpendicular to the work.
What is a "fish tail" gauge?
This procedure is done to ensure the spindle is directly perpendicular to the table
What is "tramming the mill?"
A craftsman can be assigned no more than _ manhours of maintenance per workday
What is "8 manhours?"
This procedure is similar to grinding in a valve seat but will remove slightly larger irregularities
What is "lapping?"
This equation can be used to determine appropriate RPM when turning
What is SFM(12) / 3.1416(D)
The threading tool is formed to this included angle for making American Standard and many other threads.
What is 60 degrees?
These two wrench sizes are the only two you need for the bridgeport universal mill
What is the 3/4" and 7/8" wrench?
Historical maintenance can be spotchecked in this timeframe
What is "13 weeks?"
This type of valve should not be used to throttle flow within the line, due to turbulence.
What is a "gate valve?"
This material holding device can accurately hold awkwardly shaped items concentric to the spindle
What is "the 4 jaw chuck?"
Pitch can be described and measured in this way
What is "the distance between the crest of two threads?"
This equation will help calculate the thickness of the material removed by each cutting edge per revolution
What is "Chip load?" Feed rate (ipm) / RPM x number of teeth
This person is overall responsible for the 3M program
Who is the "XO."
The valve disc should never be used to lap a globe valve. Instead, use this tool.
What is a "lapping tool?"
The tailstock uses this standardized internal taper.
What is a "morse taper?"
The "V-sharp" thread is largely used in what modern day application?
What are "Steam Tight Joints?"
This cutting method should only be used for light finish cuts or when backlash between the table feed nut and lead screw does not exist.
What is "climb milling?"
This "self-check" is performed after the force revision has been approved by the Department Head in Sked
What is a "SEER?"
The purpose behind a double lead thread of a valve stem is this purpose.
What is "faster operation?"