BLUEPRINTS
What is a BLIND hole?
These are used as reference part(s) for verify instrument readings.
What are gage blocks?
This is what SPC stands for.
What is statistical process control?
A control chart is a tool that could be used to determine how many good parts it will produce, also known as process _______.
What is capability?
Cause and effect diagrams help during the _____ phase of the plan-do-check-act (PDCA) cycle.
What is plan?
These are two types of assembly drawings.
What are exploded and basic?
To convert inches to millimeters, multiply by this number.
What is 25.4
A common measure of a quality assurance system is monitoring the number of _____ produced.
What are defects?
This chart plots the average value of subgroups of samples.
What is an x bar chart?
This document assures uniform results from worker to worker, task to task.
What is a checklist?
This is a line type that is usually parallel to the item being measured and has arrowheads on each end.
What is a dimension line?
This is the resolution (discriminiation) of calipers.
What is .001 or one thousandth?
The ISO ______ certification documents standards within an organization.
What is 9000?
A normal curve, shows the central tendency of data. This central tendency is a normal or 'gaussian' curve. This chart is most often used to make this determination.
What is a histogram?
This document is abbreviated as ECN and could signal changes to a drawing, part or process.
What is an Engineering Change Notice?
These two concepts become important when analizing mating parts. (acronyms)
This hand held measurement tool can measure down to 'tenths' (one ten-thousanth of an inch) with it's vernier scale.
What is a micrometer?
Process quality can be improved by eliminating ________ control.
What is human or employee?
A histogram with bimodal distribution most likely indicates there are ____ distinct data sets.
What are two?
In a corrective action report (CAR) the answer to "What were the results?" must include this.
What is Data that demonstrates the effectiveness of the action?
Geometric dimensioning and tolerancing (GD&T) refers to tolerances which control in these five categories.
What are form, profile, orientation, location, and runout?
To properly apply torque to a fastener, a torque wrench should be first _______.
What is calibrated?
Sample parts for inspection must be selected ______ to ensure inspectors are seeing the typical characteristics of that lot/batch.
What is randomly?
This chart is used to identify which problems should be prioritized for correction.
What is a pareto chart?
This analysis (Acronym), is conducted as early as possible in the design process to vet out potential problems that may occur.
What is DFMEA? (Design Failure Mode Effect Analysis.