Who must complete inspection prior to each shift
A competent person
The crane functions that cause two blocking are .?
Extending boom
booming down
hoisting
Lubricants must not hinder visual inspection
Rope
Up to .75 What is the distance
4 ft clearence
Device which measures horizontal?
Boom angle indicator
At least every —- the equipment must be inspect by a ——???
12 months. Competent person
What’s it called when u drag or pull material wit crane ?
Side loading
What indicate core failure on wire?
Protrusion kinking distoration
Over 550 to 750
35 feet
Meaning the load travel or area near a load placement
Not in full view of operators
What must be retained for a minimum of 3 months?
Document of inspection and who inspected it .
If deemed necessary what can u do to stop out of control load?
Use tagline
What must be done if the correct number of wires are broken ?
Must be tagged out and deemed of service and
If taglines are use they must be ?
Nonconductive polypropylene
Hand signals must be either ——— on ———or conspicuously or in ——operations
Posted
Equipment
vicinty of hoistingStablizer jacks must have An integral holding device
One way check valve
To the operators perception of signals must be by?
Hands free device
Shift inspections criteria must be followed with records ?
maintained by employers minimum of 12 months
Over 750 to 1.000
20feet
The total load with a personal platform must not exceed what percentage
50% of rated capacity
To use conditions is such that there is reasonable damage or excessive wear, the employers must stop using equipment
Severe service
Maximum allowable load a crane gives?
Rated capacity
Inspections must include for maladjustment interfering with proper operation?
Control mechanisms
Including rigging and lifting accessory’s closser to 20 feet of A.D PROCESS WHAT GUIDELINES SHOULD U FOLLOW?
Opt 1 deenergize and ground
opt 2 20 foot clearence
opt3 table a Clearence
The system use to connect the personal platform to the equipment must allow the plat form to remain with in ——-regardless of boom angle
10 degrees of level