CRASH -n- Burn
Legally Speaking
Wear It, Don't Forget It
Beat the Heat!
The More You Know
100
Telescopic, Gantry, Crawler, Harbour, Overhead, Locomotive.
What are Cranes?
100
This federal agency is responsible to protect employee’s safety at the workplace.
What is OSHA?
100
OSHA recommends that this vented or unvented PPE get replaced every 3-5 years, depending on the nature of the work being performed.
What are hardhats?
100
The time it takes to build up a tolerance to heat.
What is 2 weeks?
100
They are required to update alternative workplace labeling.
Who is the employer?
200
The strategy to eliminate all traffic fatalities and severe injuries, while increasing safe, healthy, equitable mobility for all.
What is Vision Zero?
200
The OSHA Standards for Construction and General Industry are known as:
What is Part 1926 and Part 1910?
200
To achieve a higher NRR rating for extended exposure, you should wear this.
What are ear muffs and ear plugs?
200
Headache, dizziness, or fainting
Weakness and wet skin
Irritability or confusion
Thirst, nausea, or vomiting
Are symptoms of this type of illness.
What is heat exhaustion?
200
The frequency the SDS binder goes under review.
What is annual?
300
An evaluation of each PIT operator’s performance is conducted at this frequency.
What is 3 years or less?
300
This contains or has the potential to contain a hazardous atmosphere, material with the potential engulf someone, and internal configuration that might cause someone to be trapped or asphyxiated.
What is a permit required confined space?
300
The extent of damage caused by exposure to noise is dependent on these two factors.
What is intensity and duration?
300
List 3 actions that can aid in protecting workers from heat.
What is working in pairs, drink water, wear light clothing, take frequent short breaks, and avoid caffeine?
300
This document has 16 sections.
What is an SDS (safety data sheet)?
400
A person that possesses a recognized degree, certificate, or professional standing, or has extensive knowledge, training, and experience, and can successfully demonstrate the ability to solve problems related to rigging loads.
What is a qualified rigger?
400
Employers must report fatalities to OSHA within ___ hrs.
What is 8 hours?
400
A sign that displays the health, flammability, instability, and special hazards of any chemical.
What is the NFPA Diamond?
400
The employer must provide this to workers and supervisors prior to working in the heat.
What is training [about the hazards of heat exposure & prevention]?
400
What is Health Hazard?
500
This controls the upper limit of travel of the load block, and should never be used as an operating control.
What is the Hoist Limit Switch?
500
Any facility that stores or uses a defined “highly hazardous chemical” must comply with this OSHA program.
What is PSM (Process Safety Management)?
500
Electrical gloves must be sent for testing at this frequency.
What is 6 months?
500
Temperature and humidity are two factors taken into account when measuring this.
What is heat index?
500
This is a type of exposure which can be expected to occur in the course of employment as part of an employee’s job duties.
What is Routine Exposure?