Parts
This pressurizes the oil
Oil pump
These 3 things are replaced during a tune-up
oil filter, pump screen, oil nozzle
You need this to check spark on an igniter
insulated screwdriver
These 3 things are needed for combustion
air, spark and fuel
These are the 3 ways to run an oil line
Single pipe, 2 pipe and tiger loop
This controls burner operations
Primary control
This is how you tighten the screws on an oil pump
corner-to-corner/star-pattern/concentrically
This helps you remove spin-on filters
strap wrench
This is the first step in the sequence of operations
call for heat
This is what oil lines are usually run with
3/8 copper
This connects the motor to the pump
Pump coupling
These are the 2 ways to check an igniter
Spark and resistance
This is used to check the exhaust for soot
smoke pump
This is what you recommend when you find a sludged filter
emergency tune-up
This is why a draft damper is used
consistent air for combustion
These are the 3 nozzle spray patterns and their symbols
What is
A - hollow
B - solid
W - semi-solid
These are the steps when checking combustion
Smoke test, analyze combustion, adjust, smoke test
These are the 2 types of tools used to align electrodes
T-gauge; Z-gauge
This happens after pre-purge
solenoid opens
This is the z-dimension
how far the nozzle sits into the heat exchanger
This is the out-of-the-box pump pressure
100 psi
These are the acceptable ranges for O2 and CO2
5-7% O2; 10-14 CO2
This can only be used to align electrodes on AFG burners
Z-gauge
This is the term for air bubbling out of the oil due to high vacuum
Outgassing
This is how TT is usually configured on a boiler
jumped