Safety
What shade lense is required when cutting with oxyfuel?
Shade 4 to 6
This should be attached to a new full gas cylinder before opening or cracking cylinder.
What is gas regulator?
Which of the following has the highest flame temperature when burned with oxygen? acetylene MAPP Propane Propylene
What is acetylene?
This should be used to transport oxyfuel cylinders.
What is cylinder cart?
What is a cut made at a 45 degree angle called
What is a bevel?
Heat is NEVER applied directly to a fuel or oxygen cylinder because it will do this.
What is explode?
What colors are the oxygen and acetylene cylinder hoses?
What is oxygen green and acetylene-red or black
Acetylene regulator setting cannot exceed how many PSI?
What is 15 psi?
Apply this to test for leaks on oxyfuel equipment.
What is non-oil-based detergent and water solution?
Use two piece cutting tips when using gases other than...
What is acetylene?
Use these to prevent sparks from entering and burning the ear canal.
What are ear plugs?
The location of the primary fuel gas and oxygen valves on a combination-cutting torch.
What is torch handle?
How hot does acetylene burn?
What is around 6000 degrees F
When lighting the oxyfuel gas combination torch, which should you open first - the fuel gas torch or the preheat oxygen valve?
What is the fuel gas torch?
Another name for the gap produced during a cutting process is ...
What is kerf?
Oxyfuel cutting operations should NEVER be done without this...
What is a flashback arrestor?
what is the protective measure called that keeps a cylinder from exploding?
What is rupture disk or Fusible plug
What chemical is inside of an acetylene cylinder to help stabilize the Acetylene?
What is acetone?
The oldest and most common material used for marking metal prior to cutting.
What is soapstone?
The result of moving too fast when oxyfuel cutting.
What is incomplete cut?
Protective caps should remain on gas cylinders EXCEPT when they are...
What is secured for use or in use?
When turning on an oxygen cylinder, you should open the cylinder valve this far...
What is all the way?
This is combined with calcium carbide to produce acetylene.
What is water?
How far above the base metal a cutting tip should be when starting a cut.
What is 1/8-3/16" "
When making a piercing cut with the oxyfuel cutting torch, this should be done after preheating the metal and before pressing the cutting level.
What is raise the tip 1/4" above the metal?