HAND TOOLS
How can a pipefitter be sure of the load rating of a particular jack stand?
WHAT IS
A pipe that is horizontally aligned is referred to as being _____.
WHAT IS
LEVEL
Pipe joint misalignment is checked with a _____.
WHAT IS
Hi-Lo gauge
A device that allows a tool to rotate in only one
direction.
WHAT IS
RATCHET
A sharp, ragged edge of metal usually caused by
cutting pipe.
WHAT IS
burr
WHAT PURPOSE SHOULD A HAND TOOL BE USED FOR?
WHAT IS
Only for their intended purpose
TO PREVENT DAMAGE TO THE PIPE, WHAT TYPE OF WRENCH SHOULD BE USED ON CHROME PLATED PIPE?
WHAT IS
STRAP WRENCH
When threading pipe using a manual pipe threader, the thread cutting process is complete
when how many threads extend from the back of the last tooth?
WHAT IS
ONE
Short welds used to hold parts in place until the final
weld is made.
WHAT IS
TACK WELDS
A round raceway, similar to pipe, that contains
conductors.
what is
conduit
IF A LARGE OBJECT NEEDS TO BE HELD IN PLACE, WHAT TYPE OF VICE WOULD BE APPROPRIATE?
WHAT IS
Chain or strap
WHAT IS A PROTRACTOR USED FOR WHEN IT IS HELD ON A COMBINATION TRY SQUARE?
WHAT IS
LAYOUT AND MARK ANGLES
A HICKEY IS A HAND TOOL THAT IS USED TO WHAT?
WHAT IS
BEND PIPE
A tool used to determine how many threads per inch
are cut in a tap, die, bolt, nut, or pipe. Also called a
pitch gauge.
WHAT ISGE
THREAD GAUGE
A tool used to make male threads on a pipe or bolt.
what is
Die
Which type of wrench is used for working in tight
quarters, because of their angles which
make it easier to reach pipe?
WHAT IS
OFFSET WRENCH
WHAT HAND TOOL IS USED TO REMOVE INTERNAL BURRS ON THE PIPE?
WHAT IS
reamer
WHAT IS THE SIMPLEST HAND BENDING TOOL?
WHAT IS
SPRING BENDER
Threads on the inside of a fitting.
WHAT IS
FEMALE THREADS
Outside diameter
A measurement of the outside width of a pipe.
what is
Outside diameter
Which tool would be used for aligning two sections of pipe, finding and laying out the center
lines of pipe, laying out guidelines for cutting steel and pipe, then squaring up adjustment
markings at right angles?
WHAT IS
Framing square
To align bolt holes when connecting flanges and structural steel, use a _____.
WHAT IS
DRIFT PIN
WHAT ARE THE THREADS ON THE INSIDE OF A FITTING CALLED?
WHAT IS
FEMALE THREADS
A measurement of the outside width of a pipe.
WHAT IS
Outside diameter
A pipe end that has been forced open to make a joint with a
fitting.
WHAT IS
FLARE