PHASE III JEOPARDY

BLOCK I

100

What is the maximum weight on the MH60S/R/H Cargo hook is capable of handling?

6k H/R

200

How many cabin lights are there and where are they located?

3: tunnel, s/o seat, AFT cabin

300

What is the purpose of the Main Gear Box Oil Filter?

Filter the oil in the MGB

400

The Air Data Computer supplied what four things to the avionic system?

Airspeed, altitude, vertical speed, outside temp

500

What are the Auxiliary Fuel Tanks Receptacles located and what is their purpose?

AFT cabin bulkhead; allow transfer of fuel 

BLOCK II

100

What is the purpose of nonskid?

To prevent spillage

200

What agent may cause cancer, and what are the components?

Copper beryllium; lockpin puller and droop stop 

300

What interval are aircraft washed on shore and at sea?

Shore every 14 days, sea every 7 days 

400

What two areas must be paid particular attention during corrosion inspection? 

Gearboxes and avionics

500

Explain how a helicopter should be washed and why?

Bottom to top, AFT to forward; to prevent streaking

BLOCK III

100

Discuss the danger area of the H-60 engine?

#1 and #2 Engine intake/exhaust, ECS exhaust, APU exhaust, main rotor and tail rotor

200

What kind if power plant does the H-60 utilize?

Front Driven Turbo Shaft (T700-GE-401C)

300

What sections make up the engine and what are they?

Intake, compression, combustion, turbine, exhaust

400

What model helicopter is the Hover infrared Suppression System installed on?

Sierra, Hotel

500

How many types of fuel can the T700 engine use and what are they?

3: JP-4 (F40), JP-5 (F44), JP-8 (F34)

BLOCK IV

100

What takes place when hydraulic fluid is decomposed by heat?

Toxic gases are released

200

Explain what the hydraulic patch test is?

Used to measure metallic and non-metallic contamination levels

300

Which pumps are located on the input modules inside the hydraulic bay?

1 + 2

400

How many hydraulic pumps are on the H-60F/R/S?

4

500

Where are the back-up pumps located in the helicopter? What is it used for?

Forward of #1 pump; when 1+2 fail, used for hydraulics

BLOCK V

100

What are several warning signs to be observed prior to applying external power?

Correct circuit breaker is pulled, no one is working on electrical equipment, everyone is ready for power

200

What is current, resistance, hertz, and voltage?

Current: direct movement of electrons

Resistance: opposition of current

Hertz: increase in cycles, frequency

Voltage: pressure from electrical power source

300

How many generators does the H-60 have and where are they located?

3: forward of each accessory mod, in front of APU

400

Each generator provides how many volts?

115

500

How many Generator Control units (GCUs) are on the H-60 and what is their purpose?

3: regulate output and provide over/under voltage protection