STAINLESS STEEL THREADED FITTINGS SHALL BE SCHEDULE ________ OR GREATER.
SCHEDULE 40.
DIVISION B 2.2.6.11.
DWV
drain, waste and vent.
WHAT DOES AWWA STAND FOR?
AMERICAN WATER WORKS ASSOCIATION
American Water Works Association is an international non-profit, scientific and educational association founded to improve water quality and supply. Established in 1881, it is a lobbying organization representing a membership of around 50,000 members worldwide.
ALL VALUES IN THR NPC, OTHER THAN NOMINAL PIPE SIZES ARE GIVEN IN MRTRIC UNITS?
TRUE OR FALSE?
TRUE.
BONUS QUESTION FOR DOUBLE OR NOTHING.
IS THERE A CONVERSION TABLE FOR METRIC TO IMPERIAL LOCATED SOMEWHERE IN THE NPC?
WHAT DOES NPC STAND FOR?
NATIONAL PLUMBING CODE OF CANADA 2020.
The National Plumbing Code of Canada (NPC) 2020, developed by the Canadian Commission on Building and Fire Codes and published by the National Research Council of Canada, sets out technical requirements for the design and installation of new plumbing systems, as well as the extension, alteration, renewal and repair of existing plumbing systems.
WATER CLOSETS SHALL BE PROVIDED WITH A ______ - ___ ________ ON THEIR WATER SUPPLY PIPE?
SHUT-OFF VALVE
DIVISION B 2.6.1.3.4)
TRUE OR FALSE?
VENTING SYSTEMS FOR DRAIN PIPING, NEUTRALIZING TANKS OR DILUTION TANKS CONVEYING CORROSIVE WASTE SHALL EXTEND INDEPENDENTLY AND TERMINATE OUTDOORS.
TRUE.
DIVISION B - 2.5.5.3.
cm2
square centimetre(s)
The slow movement of the valve disc near the full-closed position results in high-fluid velocities, causing scoring of seating surfaces, referred to as:
Wire Drawing. It also causes galling of sliding parts.
WHAT IS NON-POTABLE WATER?
WATER NOT FIT FOR HUMAN CONSUMPTION.
Non-potable water is not treated to drinking water standards and is not meant for human consumption. Non-potable water, such as raw (untreated) water from reservoirs, is used for irrigation and other purposes, in addition to recycled water (highly-treated wastewater).
WHAT DOES ASHRAE STAND FOR?
The American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE /ˈæʃreɪ/ ASH-ray) is an American professional association seeking to advance heating, ventilation, air conditioning and refrigeration (HVAC&R) systems design and construction. ASHRAE has over 50,000 members in more than 130 countries
DRAINAGE PIPE THAT SERVES A WATER CLOSET SHALL BE NOT LESS THAN ________?
NPS 3
DIVISION B 2.4.9.2.1)
WHAT IS THE MINIMUM NOMINAL PIPE SIZE OF A SINK DRAIN?
1 1/2"
DIVISION B - 2.4.9.4
TABLE 2.4.9.3
Lpf
litre(s)per flush
WHAT DO THE ABBREVIATIONS "BG" AND "CW," STAND FOR?
- BATHROOM GROUP
- CLOTHS WASHER
WHAT IS AN EXAMPLE OF CLEAR-WATER WASTE?
WATER DISCHARGED FROM A:
1. DRINKING FOUNTAIN
2. COOLING JACKET
A cooling jacket, also referred to as a flow generator, ensures that there is always sufficient water flow across the motor surface in order to cool the motor. In a typical well installation, the pump is surrounded by the walls of the well. The motor is installed below the pump.
3. AIR CONDITIONER
4. RELIEF VALVE (HWT)
WHAT ARE SEISMIC RESTRAINTS AND DESIGN?
Seismic Restraints are elements designed to keep nonstructural components from moving during earthquakes. Each seismic restraint includes 3 main components: Connection between the Restraint and the Nonstructural components. The Seismic Restraint main element.
2.1.4.1.(1) AIMS TO HELP ENSURE THAT PLUMBING SYSTEMS WILL REMAIN IN PLACE FOR A SUFFICIENT AMOUNT OF TIME DURING AN EARTHQUAKE TO ALLOW FOR SAFE EVACUATION OF THE BUILDING.
THE TEMPERATURE OF WATER DISCHARGING FROM A SHOWER HEAD OR INTO A BATHTUB SHALL NOT EXCEED ________ DEGREES C?
49 DEGREES C or
120 DEGREES F.
(IN HEALTHCARE FACILITIES AND SENIORS' RESIDENCES IT BECOMES 43 DEGREES C.)
OH HEALTH
SANITATION: AN OBJECTIVE OF THIS CODE IS TO LIMIT THE PROBABILITY THAT, AS A RESULT OF THE DESIGN OR INSTALLATION OF THE PLUMBING SYSTEM, A PERSON IN THE BUILDING OF FACILITY WILL NOT BE EXPOSED TO UNSANITARY CONDITIONS. NAME 2 OF THE 4 UNSANITARY CONDITIONS ADDRESSED IN THE CODE?
OH2.1 - EXPOSURE TO HUMAN OR DOMESTIC WASTE.
OH2.2 - CONSUMPTION OF CONTAMINATED WATER.
OH2.3 - INADEQUATE FACILITIES FOR PERSONAL HYGIENE
OH2.4 - CONTACT WITH CONTAMINATED SURFACES.
DIVISION A - 2.1.1.1
diam.
diameter
WHAT TYPE OF GLOBE VALVE IS USED FOR BOILER BLOW-OFFS AND SERVICE WHERE MUD, GRIT AND /OR VISCOUS FLIUDS MAY BE ENCOUNTERED?
Y pattern globe valves are used as an alternative for the high pressure drop inherent in standard globe valves. The Y type design reduces the flow resistance of the globe valve to a minimum.
Who (What Industry and Applications) uses ball valves?
Name three?
They are commonly used in industries such as petrochemical, water treatment, HVAC, and pharmaceuticals, breweries, fertilizer plants. Low Maintenance: Ball valves require minimal maintenance because of their simple design.
NAME TWO METHODS FOR SUPPORTING UNDERGROUND PIPE?
1. SAND, CRUSHED ROCK, OR FIRM EARTH ROCK.
2. LAYER OF CONCRETE.
3. FIRM EARTH WITH A BELL HOLE.
4. CONCRETE ENCASEMENT.
NOT ALLOWED - UNSTABLE FILL WITH PIERS, PLANKING OR BOULDERS.
DIVISION B - A-2.3.4.6. (1)
WHEN A HANGER OR SUPPORT FOR COPPER TUBE OR BRASS OR COPPER PIPE IS OF A MATERIAL OTHER THAN BRASS OR COPPER, WHAT MUST BE DONE?
IT SHALL BE SUITABLY SEPARATED AND ELECTRICALLY INSULATED FROM THE PIPE OR TUBE.
BONUS QUESTION FOR DOUBLE OR NOTHING!
ELECTROLYSIS
What effect does electrolysis have on metal?
WHAT ARE THE FOUR STATED OBJECTIVES OF THE NPC?
1. SAFETY
2. HEALTH
3. PROTECTION OF THE BUILDING OR FACILITY FORM WATER DAMAGE OR SEWER DAMAGE.
4. ENVIROMENT.
NPC page vi - Division A 2-1
PE-RT
POLYETHYLENE OF RAISED TEMPERATURE.
NPC 1.4.2.1.
FILL IN THE BLANKS WITH CORRECT COLORS.
PVC CEMENT SHALL BE ________.
ABS CEMENT SHALL BE ________.
CPCV CEMENT SHALL BE ________.
TRANSITION CEMENT SHALL BE ________.
PCV = GREY
ABS = YELLOW
CPVC = CLEAR
TRANSITION = WHITE
DIVISION B - 2-79
WHAT ARE THE THREE DIVISIONS OF THE NPC?
DIVISION A - COMPLIANCE, OBJECTIVES AND FUNCTIONAL STATEMENTS.
DIVISION B - ACCEPTABLE SOLUTIONS.
DIVISION C - ADMINISTRATION PROVISIONS
NPC page ix
What's the difference between wet and dry venting?
A wet plumbing vent drains water from one fixture while ventilating the air, among other fixtures. On the other hand, a dry vent only transports air and does not carry water. This is to say that wet vents may drain one fixture and vent another, whereas dry vents typically vent air from a single fixture at a time.
HOW SHOULD EVERY LENGTH OF PIPE AND EVERY FITTING BE IDENTIFIDED?
HAVE CAST, STAMPED OR INDELIBLY MARKED ON IT THE MAKER'S NAME OR MARK AND THE WEIGHT OR CLASS OR QUALITY OF THE PRODUCT, OR BE MARKED IN ACCORDANCE WITH THE RELEVANTSTANDARD.
INDELIBLY - that cannot be erased, blotted out, eliminated, etc.; permanent; lasting.
Division B: 2.1.4.1.