Show:
SPT #1
SPT #2
SPT #3
PPT #1
PPT #2
100
On a table saw cutting long, narrow stock across it's width is done safely using this accessory
What is a mitre gauge
100
This is the maximum distance a tool rest should be set from the face of a grinding wheel.
3 mm
100
At what distance is it recommended you use a push stick, while operating a table saw?
When the distance between blade and fence is 4" (100 mm) or less
100
What type of chuck do routers and laminate trimmers use
What is a collet
100
When installing a blade in a circular saw, the blade should be positioned to cut in which manner?
Upward through the material
200
How does a splitter (riving knife) help prevent kickback from occuring while operating a table saw?
Prevents material from making contact with back portion of the blade.
200
The table saw accessory stops material from kicking back towards the operater
What are Anti-kickback fingers
200
When using a band saw, how high should the upper guide post be set about the material being cut?
What is 6 mm (1/4")
200
What type of drill is used for close quarters drilling
What is a right angle drill
200
Cutting with a standard jigsaw blade, how should you position your material
What is good side down
300
A radial arm saw is said to be in "in-rip" position when...
The blade is towards the column and the motor is between the operator and the blade
300
List the 3 common radial arm saw configurations
Single overarm, Double overarm, Sliding overarm
300
To ensure a properly jointed surface which part of the jointer needs to be adjusted
Outfeed table To what height?
300
What determines the size of a power plane
What is the maximum cut width of the cutter
300
When cutting around the outside edge of material, what direction should the router travel
What is Counter Clockwise
400
What is the name of the metal tube that is moved vertically using spring and levels to operate a drill press?
What is the quill
400
This type of cut can be achieved by a radial arm saw, but not by a sliding mitre saw
What is ripping long material
400
What distinguishes a screw gun from a drill?
Drills = Chuck Screw gun =hexagon magnetic bit holder
400
List the 3 standard router base styles
Rack and Pinion Helical Plunge
500
To check the tension on a band saw, how much should the blade move when light finger pressure is applied?
3 mm (1/8")
500
How are bevel cuts made on the band saw? What is the range of angles that can be cut?
Tilting the table 45 deg to the right 5 to 10 deg to the left
500
This component is placed between the arbor nut and the blade on a table saw.
What is the arbor washer
500
What two type of cutter heads are used in power hand planes
Spiral cutter head and two blade
500
What is a platen? What does it do?
Flat shoe section between rollers of a belt sander provides solid backing for sanding belt.