Band Saw / Jig Saw / Scroll Saw
Curves and irregular shapes
What is the band saw used for
Guide used for ripping
Fence
This machine is used for:
Drilling holes
This machine is used for
Smoothing surfaces
What is this machine used for?
Shaping ends and edges of lumber.
Adjust the upper guide to no more than ____ inch above the stock
¼ inch
Stock must be at least ____ inches long to be cut safely.
12 in
Tighten the bit with the ____.
Chuck key
Hold stock ____ when sanding.
Firmly
Move stock from ____ to ____ when routing
Right to Left
Feed the stock only as fast as the teeth will easily ____ the wood
Cut
Hold the _______ edge of the board along the fence to avoid kickbacks.
Smooth
Place the majority of the stock to the ____ of your body.
Left
If a safe margin cannot be maintained, __________.
Do not use
Whenever possible, use the ____ as a guide
Fence
If the blade ____ notify your teacher immediately.
Breaks or makes a clicking noise
If you can’t maintain a 4” margin of safety, use a ____.
Push Stick
Work should be ____ securely before drilling.
Clamped
When using a disk sander, sand on the side where the disk rotates ____.
Down
Check to be sure the ____ unit is attached before turning on
Margin of safety for this saw
4"
Guide used for Crosscutting
Miter Gauge
Check twice to make sure the chuck key is ____ before turning on.
Removed
Never allow your work to remain ____ while sanding.
Still
15,000-30,000