R
TRUE or FALSE.
All jobs are to be proofed by a second person before being released to film.
TRUE
What does NCR stand for?
Non-Conformance Report
What does GMP stand for?
Good Manufacturing Practices
TRUE or FALSE
Ensure that sealer is applied on top of tape that is past the floor of the plate when mounting plates.
FALSE
The sealer will have no chance to have an effect due to tape being between the carrier and the plate. Never try to seal on top of tape.
What is the name of our Mascot?
Nynuk: The Polymer Bear
A customer complaint is received when an internal process failure is identified, what must be created?
Non-Conformance Report (NCR)
When patching Multiple colour jobs with tight registration and trap, it must be done with the repeat.
What is Repeat?
Repeat is the direction of the cylinder (Lead Edge to the top).
What is an international organization that develops standards for industrial and organizational quality?
ISO
Half of a split plate is not within spec for height causing ghosting on one side of the print. What verification could have prevented this from reaching the customer?
Caliper Verification
Plates are not getting enough consistency from the spiked roller leaving air pockets. How can we correct this?
Increase number of passes with the spiked roller and ensure penetration through the tape.
What do you do when you get the transparency alert in PDF Preflight?
Add a note in Film Instructions that says ‘Transparencies in File’.
What is the name for the systematic food safety management system used to identify, evaluate, and control hazards that could compromise food safety throughout the production process?
HACCP - Hazard Analysis Critical Control Points.