Converting Quality
What does FFG stand for?
What is Flexo Folder Gluer
How many 16ths of an inch can you be out of spec on total length or total width of a corrugated sheet?
What is 1/16th of an inch
What is the terminology of an order type that is equivalent toa warehouse release order?
What is a call off
GMP is the acronym for what?
Good Manufacturing Practices
The defined process of "Assuring that the lines are cleared between order runs to ensure that products are not comingled" is called what?
What is Line Clearance
What is always the "NO FAIL BASICS" if you cannot make a box/sheet to spec?
What is call your supervisor
How many passing scans must each barcode have on a box?
What is 3 scans
what is the name of the quality check that measures the strength bond in a corrugated board?
What is Pin Adhesion
Our strapper operators and shippers are often referred to as out last line of _______ because they are the last ones to see our product before our customers?
What is Defense
What does HACCP stands for?
Hazard Analysis of Critical Control Points
What is the terminology used for a sellable sample box/sheet that is marked up with dimensions and print checks sitting at the machine-side table during order runs?
What is a strike Box/board
What is the name of the computer program that we use to track and enter quality checks during an order run?
What is QMS
What is our range for Ink Viscosity?
What is 18-26 seconds
What is the test frequency of a soak test?
What is 2-hour intervals
What are 2 things that the strapper/bander operator should be looking for when evaluating the overall quality and appearance of a unit?
What are missing straps. straps too tight/loose, incorrect dunnage, no tie sheets, scrap, straight and uniform loads, correct load tags/unit counts, visible load tags, contamination, and or customer special instructions.
GMP's are universally regulated and enforced by what government agency?
What is the FDA (Food & Drug Administration)
What is the defined term of "checking on box per unit" called?
What is a box assessment
When a die board needs to be repaired what color tag should be placed on the die board with a sample of the defect?
What is the color Red
Name 4 things that must be on your Strikebox?
What are Dimensions, Print Check, Caliper, glue fiber tear, score line markings, Arrows/clear writing, checked off spec sheets, sign offs by (op, assist, helpers and supervisor)
What is the target combined board moisture?
What is 7.5%
What is a legal document between the shipper of a particular good and the carrier called?
What is a BOL/Docket
Good hygiene, no food , no drink, and no Tobacco use on the floor are examples of what?
What are Good Manufacturing Practices (GMP)
What does RMA stand for?
What is Returned Material Authorization
When a unit or multiple units are found to be out of specification, what item must be placed on them before they are sent to the rework area?
What is a completed orange hold tag sticker?
What is the target range for gap?
What is a .375 3/8" target with .250 1/4" to .500 1/2" range
Name 2 raw materials used in the production of corrugated board?
What is roll stock/paper, steam, adhesive, and starch
What menu is used in our scanning system when you need to move or change a unit/load?
What is the Fork Hoist Menu?
What 3 hazards does the HACCP program address?
What are Biological, Chemical, and Physical Hazards
What does DPPM Stand for?
What is defective parts per million
What is the following statement called? "We aspire to be the premier partner and unrivaled provider of winning solutions for our customers".
What is the Quality Policy?