Engine Start up
What do you need to turn on when you intended to start a cold engine?
Choke/Enrichment System
This needs to examined to read how each cylinder is running.
Spark Plug
This is considered the first snowmobile company ever.
Ski-doo
What is the typical Fahrenheit reading that should be near the head of an engine?
1200 Degrees
If you need to keep all engine parts in alignment. What part would you be?
Engine Block/Crankcase
When considering engine internal components. Why do you need to allow you engine to warm up?
Allow for heat expansion
This tool is used to diagnosis simple 12 volts problems.
Test Light
This component is what moves the transmission gears in manual and automatic transmissions.
Shift Fork
What is the most common spot to set valves on a four-stroke engine?
TDC compression stroke.
If the main nozzle of a carburetor is clogged and gummed up. What tool would you use to clean?
Ultra Sonic Machine
In an EFI system what does the ignition system do to aid in start up?
Advance timing
If you had a machine that keeps breaking drive chains. What would you check first. (Not EASIST possible solution)
Alignment/Chain Alignment/Chain Tension
Slide Valve
If a two-stroke engine had fuel spitting out of the carburetor. What is the possible bad component?
Reed Valve
This first process is commonly used in engine component production.
Casting Parts
In an EFI system. What is done to the fuel system to aid in starting and running of a cold engine?
Injector Length Exteneded
If you had an engine that was popping out of the exhaust and adjusting the carb mixture was not doing anything (Carb is Clean and Ignition System is working properly). What is the possible cause of the lean popping.
Air leak in intake system.
What component is manipulated to change the top RPM in a centrifugal clutch.
Clutch Weight/Secondary Spring
What is used when you need to get a suggested procedures to diagnose engine problems.
Troubleshooting flow chart
This process hardens the outside of the engine part to ensure it can have a long life.
Case Hardening
What is added to the engine oil to allow it to flow better at colder start-up temperatures.
Viscosity Improvers/Paraffin
If you have an excessive amount of tire wear on the inside of both the front tires, and your alignment is correct. What is the probable cause.
Worn out suspension
What is the common ignition style used on carbureted two stroke engines?
CDI
What is used to keep the crankshaft lubricated when a two-stroke engine is run in all different positions?
What is added to Aluminum to lower its weight for performance applications.
Magnesium