ResiStar Tool Components
This houses the programmable logic control (PLC) Board and provides power to other PCB boards.
What is the Electronics Insert Collar?
Two measurements are made between two receivers, at each frequency.
What is Phase Shift and Attenuation (Amplitude) Resistivity?
The Resistar tool will sample on this antenna at every cycle.
What is the receiver antenna?
This measures the resistivity mud and uses the information for environmental corrections.
What is the mud button?
This type of resistivity is more sensitive to dialectric effects.
What is Attenuation resistivity?
The Resistar tool will perform frequency firing on this antenna at every cycle
What is the transmitter antenna?
This antenna receives the electromagnetic waves that travel through the formation. There are two of these in the ResiStar tool.
What is the receiver antenna?
This is the total number of compensated measurements at each measurement cycle.
What is 12?
Data will be transferred to this board through the PLC Board in the Basestar tool.
What is the Network Assisted Storage (NAS)?
This antenna transmits the electromagnetic waves in the formation. There are a total of 6 antennas.
What is the transmitter antenna?
These are the compensated transmitter-receiver spacings.
What is 16, 32, and 48 inches?
The tool will compensate the measurement using this of data and compute the resistivity measurement
What is Airhang data?
This houses the Junction Box, the transmitter and receiver antenna.
What is the Antenna Collar?
These are the two frequencies the ResiStar tool operates with.
What is 2 MHz and 500 kHz?
The Resistar tool interacts with this tool to communicate resistivity and raw data.
What is Basestar tool?