Structures
The structure that holds the launch rail
Protects your hands while working with epoxy
Gloves
These are the two parts of epoxy
Resin and hardener
3DPR stands for this
Three-dimensional printed rocket
Emily and Samir are this year in school
Emily is a Junior and Samir is a Senior
Center of gravity
Protects your eyes while bandsawing
Safety goggles
These are the steps of a fiberglass layup
Wrap, epoxy, cure, remove
GHPR stands for this
Group high powered rocket
This is Samir's major
Mechanical Engineering
The point of the rocket where sum of forces are applied
Center of pressure
This type of mask protects you while dremeling
N95 Respirator
This is the cylindrical metal mold used for laying up body tubes
Mandrels
PPE stands for this
Personal protective equipment
This is Emily's major
Computer Science & Engineering
This bulkhead is positioned above the engine to prevent it from flying through
Engine block / thrust bulkhead
These "clothes" protect you
Coveralls
Tape
RISE stands for this
Rocketry Introduction for Student Education
Emily and Samir were leads of this Rocket Project subteam
Electronics
Positive stability occurs when the center of gravity is above/below the center of pressure
Below
Where you go to spray paint
Sandbox
This is necessary to print parts with overhang
Support material
FAR (our Rocket Project launch site) stands for this
Friends of Amateur Rocketry
Emily and Samir used to intern here
NASA or JPL