This allows the Axis to move freely.
What is ball bearing ?
Service Password for Delta 2.9.1 software.
What is 24888?
this Module is where Instrument Serial number can be entered.
What is device setup?
Sigma runs these test Intem, Extem Fibtem and
What is Heptem?
This time is required for Rotrol N (sigma ) to reconstitute
What is 15 minutes?
This seals the cartridge from splashing. 
What is the Cartridge Seal?
This brass ring around the axis
What is the clean ring?
Password used to install software
What is Penta328
Distance the sigma must be from a patient
What is 1.5 meters.
Fibtem keeps this from effecting the sample
What is platelets?
This PCB is mounted on the wall between the computer module and workbench on the Delta.
What is the Con PCB (also goes by Fuse Bd)
This graph shows what is happening in the cup and pin. Also in the patient
What is the Temogram?
Module in Delta software where you can select reagent lot tracking
What is Set Up module?
In the Sigma the hard drive is mounted in the module...
What is the HMI ?
this test assesses the influence of heparin, clot formation, clot firmness and clot stability through activation of the intrinsic pathway....
What is Intem
This PCB has valves on it
What is the Rear PCB (aka Sampler handler rear PCB)
The cable from ADM 1 is plugged into this board in the Rotem delta.
What is the Con board? (or fuse bd)
The external QC on a Delta must be completed this often...
What is weekly ?
Sampler Handler serial number is displayed in this page in the software.
What is Sample Handler tab in service module
Error that you will get if cup is not fixed.
What is a plausibility error.
PCB on the right side of the sample handler

What is the Sampler Handler main board?
This device detects the light from the axis mirror.
What is the CCD sensor
This is the current Sampler Handler Firmware version.
What is 2.16?
Volume of blood needed to complete all test on the sigma.
What is 2.7ml ?
This cartridge can only be used 150 times.
What is the internal QC cartridge?