S.A.F.E lift 1 & 2
Two names commonly used for a forklift are Counter Balance Lift Truck and Powered Industrial Truck
True
If anything is identified that could cause an accident, it should be reported to your ___
supervisor
An inspection should be done at the ___ of each shift.
Beginning
All lifting, tilting, and lowering motions should be done ___.
Slowly
Ways to detect a propane leak are:
Report any defective refueling equipment to a ___ immediately.
supervisor
A ____ capacity lift truck typically weighs around 9,000 lbs.
5,000 lbs
The counterbalance ____ ____ works that same way as a teeter totter.
lift truck
If defects are found with your forklift, you should tell no one.
false
When leaving a lift truck unattended, the forks should be placed ___ __ ___.
on the floor
When changing a liquid propane cylinder, you should wear ___ ___ and ___.
safety glasses, gloves
Each battery consists of a ___ plate and a ___ plate immersed in a solution of sulfuric acid.
positive, negative
What does O.S.H.A stand for?
Occupational Safety and Health Administration
If a ___ is available, it must be worn by the operator.
seatbelt
Where do inspections of lift trucks begin?
Power Source
For clearance for rear wheel swing, an operator should position the lift truck ___ to the side that they plan to turn.
closest
Ensure the pressure relief valve points __ when installing propane cylinders.
up
Each cell in a battery produces about ___ volts of power.
2
Who can operate a powered industrial truck?
Only trained and authorized personnel.
The higher the lift, the ___ the lift capacity.
lower
The area near the front tires of the lift truck is known as the ___.
fulcrum
The parking brake is usually located to the ___ of the steering wheel on a sit down counterbalance lift.
left
Before changing a cylinder, you must let the engine run while the valve on the cylinder is ___.
off
If acid spills from the battery, use ___ ___ and water to neutralize it.
baking soda
The number one cause of accidents and fatalities is _____.
Tip Overs
The ___ ___ ___ is the place at which an object will balance on a single point. It's usually at the center of an object.
center of gravity
The part of the forklift that is located directly over the driver's head is known as the ___ ___.
overhead guard
The tires that are located near the back of the forklift was known as ___ tires.
steer
The solution of sulfuric acid and water is known as ___.
electrolytes
Add water to the battery ___ charging.
After