scroll saw
ban saw
sand tester
miter saw
random safety
167
Never put your fingers in line with the blade?
yes
167
The best time to remove scrap material from the band saw is ___________.
when the saw stops
167
what is number 2
abrasive belt
167
How must the saw blade be held after the cut is finished and before the blade stops rotating?
Hold it in the down position
167
what do to not,do in a wood work shop
goofing around,not paying attention etc
250
If you push too hard what will happen?
The blade will break
250
Which of the following is the correct procedure to determine if the blade is operating on the middle of the band saw wheel?
Turn the wheel by hand to check
250
what is number 5
abrasive disc
250
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
250
what to do when a machine isn't working properly
turn it off and notify the teacher or instructor the notify
350
Always leave the saw with the light off and the speed all the way down
yes
350
If too much cutting pressure has to be applied to make a cut, the blade __________.
is dull
350
what is number 3
disc table
350
When is it safe to remove wood scraps from the cutting zone?
While the saw is off and the hand is not on the On/Off trigger
350
what to do when you get cut in the shop
notify the instructor
450
If the blade breaks:
unplug and notify the instructor
450
It is safe to place the hand in line with the blade of the band saw __________.
only when the machine is not operating (i.e. during setup)
450
what is number 4
belt table
450
The purpose of a trial cut before making the actual cut with the motorized miter saw is to ____________
see if the saw is cutting properly and is set accurately
450
what is one thing you need to properly wear in the shop
close shoes,no lose clothes and no jewlary
600
what to do when you cutting wood?
hold your wood down foot
600
The danger zone for the band saw (where you should not stand in case the blade breaks) is:
to the right of the operator's position (next to the band saw table)
600
Keep hands and fingers at least _____________________ inches from all moving parts on any machine.
4 inch
600
How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw?
a safe speed that will not burn or splinter
600
what to do before starting a machine
Make all adjustments before turning the machine on as the teacher or the insturctor says