This and That
True or Flase: Safety stands need to be adjusted to the same height?
True
False
The most important reason to use the correct tool for the job?
Safety
What is the correct way to disconnect a electrical plug?
What is the first thing to be checked when operating a frill press?
Make sure the chuck key has been removed from the chuck.
Why should two hydraulic floor jacks never be used to jack up the front and rear of the vehicle at the same time?
The vehicle will be unstable and could fall off the jacks.
What are floor jacks used for?
Raise the car only.
What kind of explosive gas does a charging vehicle battery release?
Hydrogen
When a large gap develops between the tool rest and the stone, what should be done?
Adjust the rest to the proper clearance.
Tasteless, Odorless, Colorless Gas
Carbon Monoxide
Technician A says asbestos is found in some brake pad material. Technician B says asbestos is found in some clutch materials. Who is correct?
Both A and B
Fires that start from electrical equipment malfunctions are classified as
Type C
True or False: It is safe to stand in the direct line of the cooling fan?
False
Proper way to hook up a battery charger?
Positive battery charger cable should be connected first and disconnected last.
When a material reacts violently with water and other materials it is said to have high
Reactivity
What are the names of the parts on the hoist used to hold the car?
Saddles or Pads
What should a technician always do when running a vehicle in a shop?
Make sure the exhaust is properly vented to the outside.
When disconnecting a battery, what should be removed first?
Ground cable first.
What must a operator of a brake lathe never do?
Place a hand in a from or on a rotor while it is turning.
If a substance dissolves metals and other materials, or burns the skin it is said to be
Corrosive
What is the proper way to use a hydraulic jack?
Turn the jack handle clockwise until snug and pump
Technician A says using ungrounded plugs will reduce the risk of electrical shock in the shop. Technician B says there is a risk or electrical shock if you use electrical tools that seem to be shorting out. Who is correct?
Technician B
True
What should a technician do to safely operate a tire changer?
Keep hands clear of moving parts.
Technician A uses a dust mask to be safe when working on brakes and clutches. Technician B uses a dust mask when working around exhaust containing carbon monoxide. Who is correct?
Neither A or B