Working at Heights
A Working at Heights Permit is required while working from a ladder with the user’s feet at a height that is greater than ________ feet. The permit may not be required while using a specialty ladder that is equipped with working platforms and guardrails; for instance, Little Giants.
What is 10 feet or 3 meters
When hot work is being done you must have one of these present for the person who is responsible for the fire watch
What is a fire extinguisher
LOTOTO
What is lock out, tag out, try out
When you clean up a spill and have a bag of material to dispose of, it is logged in the log book and stored in this room.
What is the hazardous waste room
Work which is likely to produce flames, sparks, smoke, or excessive heat requires this type of permit
What is a Hot Work permit
Anyone who enters an aerial lift must tie off to one of these, and use an approved full-body harness and restraint lanyard or SRL.
What is an approved anchor point
Fire watch must be conducted after hot work has been completed for this many minutes
What is 60
What the C in RACI stands for
What is consulted
Oland and Son Limited sells its brewing assets to John Labatt Limited for approximately $12 million dollars in this year
What is 1971
This form is required if no SOP exists for a required LOTOTO, or if the SOP is overdue to be verified
What is a non routine form / non routine SOP
All portable ladders must be rated for at least this amount of weight
What is 300 lb
Remember the word “PASS” when dealing with fire extinguishers.
Pull the pin.
Aim the extinguisher at the base of the fire.
Squeeze the lever
and do this which the final S stands for
What is sweep side to side while discharging the extinguisher
SIF
What is a serious injury or fatality
SAM/LOTOTO, Hazardous substances, Electricity, Work Permits, Vehicles and this are topics covered under the 6 golden rules.
What is working at Heights
This permit is required for any work on or temporary disabling of a safety system
What is a Safety By-pass permit
Ladders need to be inspected for defects this frequently
What is before and after each use
A supervisor should retain a hot work permit for this many hours after the work is complete
What is 48 hours
ATO
What is Autonomous operations
Our goal is to reach interdependence on this curve
What is the Bradley curve
A permit for critical tasks is valid for this long
What is one shift / the rest of the shift
Straight ladders should be placed this many degrees from the support structure
What is 75 degrees
Remove or shield all combustible materials from sparks within this many meters according to regulations in Canada
What is 15 meters
the 5 S's
What are Sort, Shine, Set in Order, Standardize, and Sustain
This ship was built in 1963 by Oland and Son to market Oland products
What is the Bluenose II
This permit does not require a green tag as it already includes LOTOTO requirements
What is a confined space permit