LOTO
Whats loto stand for
lock out tag out
This limiting knot, if tied correctly and in the right place, prevents the worker from ever reaching the fall hazard.
Figure 8 knot
What is the purpose of trauma straps?
Allows the worker, who is suspended, to stand up in their harness and to relieve the pressure being applied to the arteries and veins around the top of the legs
How often should you inspect your PPE?
Every day or before you begin use
What is LOTO and why is it important?
Lockout Tagout ensures dangerous equipment is de-energized and cannot re-energize unexpectedly.
True or false? I can set a ladder going from the 1st story roof to the 2nd story roof as long as the top of the ladder is properly secured.
False. The bottom of the ladder must also be secured to the roof.
Who is responsible for setting and verifying all figure-8 knots are in their proper locations at the start of the day?
The person who signed as Fall Comp on the Site Safety Plan.
True or False? A properly fitted harness is when:
True
When engineering, work practice and administrative controls are not feasible or do not provide sufficient protection, employers must provide ____ _____ _____.
Personal protective equipment (PPE)
Daisy Chain.
It can lead to overloaded circuits and fire risk.
Person responsible for ensuring the Site Safety Plan is accurate and communicates any hazards with all employees on site.
Crew Lead
Demonstrate how to tie a proper figure-8 knot.
You are painting conduit from a ladder 6 ft above the ground. There are installers working on the roof above. What PPE do you need in order to establish safe work conditions?
Full body harness, tied off to anchor and rope, hard hat, safety gloves, and safety glasses
If you are wearing a hard hat, and a hammer falls from the roof, onto your hard hat, but there are no damages, should you discard your hard hat?
Yes
An electrical safety device that senses small imbalances in the circuit caused by current leakage to ground, and in a fraction of a second, shuts off the electricity.
GFI/GFCI - Ground Fault Circuit Interrupter
This Bolt form is used to identify hazards associated with the job and must be submitted before the start of the job.
JHA (Job Hazard Analysis)
Where should your figure 8 be placed?
At least 1 foot away, or far enough away from the edge to prevent the worker from reaching the fall hazard.
When work is complete, and all workers have left the roof, the ____________ removes lifelines and anchors, making sure to properly flash all penetrations.
Last Man Down/Last Person Down
To be OSHA compliant, what type of rating must your safety glasses be stamped with?
A. OSHA 300
B. NFPA 12
C. ANSI Z87
D. OSHA 30
Demonstrate the proper way to don all the electrical PPE in this bag.
Great job!