Show:
HAZ-COM
PSM
PPE
Hazard Recognition
Misc.
100
What does the acronym DMA stand for?
Dimethylamine
100
What does the acroynym PSM stand for?
Process Safety Management
100
What is the minimum PPE required in our Formulation Department near Vessel 8?
Safety Glasses with sideshields, safety boots, refelctive clothing, and hard hat.
100
This risk asssessment form must be filled out prior to performing routine and non-routine work on a daily basis by employees performing the work.
WHAT Card (Work Hazard Assessement Tool)
100
This form must be filled out prior to welding in any area of the plant other than the maintenance shop.
Hot Work Permit
200
What is the NFPA flammability rating for DMA?
4
200
Where is 60% DMA used and stored at our plant?
DMA railcar, pipework from the railcar to the plant, and vessels 5 and 7.
200
What PPE is required when filling shuttles of Amine 4?
1) Chemical resistant gloves 2) face shield or goggles 3) Safety Glasses 4) Safety Boots 5) Uniform (Long sleeve shirt)
200
A _____________ is an unplanned event that did not result in injury, illness, or damage – but had the potential to do so.
Near Miss
200
According to our safe lifting policy, what is the maximum amount that an employee can lift without assistance from another employee or mechanical lift aid?
70 lbs
300
Safety Data Sheets for our production chemicals are found in what two locatations?
The cabinet outside the production supervisor's office and the QC lab.
300
What does the flashing red light above the smoking area indicate?
The DMA pump is running
300
Hearing protection is required when working areas for 8hrs above what threshold?
85 dB
300
What does the acronym JTO stand for?
Job Task Observation
300
What does the PASS acronym stand for with respect to properly using a fire extinguisher?
Pull the pin. Aim at the base of the fire. Squeeze the handle. Sweep back and forth at the base of the fire.
400
How long must we keep Safety Data Sheets?
30 years after the product has been discontinued.
400
Process Safety Managment is regulated by OSHA and covers all plant employees, contractors, and visitors. What EPA regulation covers all of our surrounding neighbors?
Risk Managment Program (RMP)
400
What type of respirator cartridges are used at our facility?
GME-P100 (Hepa filter with acid gas, organic vapor, ammonia)
400
Abreviated as JHA, this is a technique that focuses on job tasks as a way to identify hazards before they occur.
Job Hazard Analysis
400
What is the most severe heat related condition?
Heat Stroke
500
Name at least 3 of the four pesticide signal words?
1) Danger 2) Danger-Poison 3) Warning 4) Caution
500
Name (3) of the 14 elements in OSHA's PSM program?
Employee Participation, Process Safety Information, Process Hazard Analysis, PSM Procedure Program, PSM Training Program, Contractors, PreStartup Safety Review, Mechanical Integrity, Hot Work Permit, Management of Change, Incident Investigations, Emergency Planning and Response, Compliance Audits, Trade Secrets
500
The effectiveness of a material to protect against chemicals is based on its resistance to what three things?
1) Penetration 2) Degradation 3) Permeation
500
How often must we perform a Process Hazard Analysis (PHA) on our DMA process?
Every 5 years
500
These micororganisms, carried in the blood, that cause disease in humans are known as.
Bloodborne Pathogens