Hand Safety
This type of glove helps prevent your hands when handling sharp materials
What are cut resistant gloves?
PPE stands for this
What is Personal Protective Equipment?
These individuals must be protected from forklift traffic and should use designated walkways and crossings.
Who are pedestrians?
These two words make up the abbreviation LOTO.
What are lockout and tagout?
This three-digit number should be called during a life-threatening emergency.
What is 911?
This is an area where your fingers can get caught between moving parts.
What is a pinch point?
This is the full name of the government agency responsible for writing, auditing, and enforcing standards related to PPE
What is Occupational Safety and Health Administration?
Forklift operators should sound this warning device when approaching blind intersections, stop signs and doorways.
What is the horn?
Lockout/Tagout prevents this.
What is the release of hazardous energy?
Smoke is in the area and the fire alarm is on, employees must report to this location.
What is the emergency evacuation point located in the parking lot?
Contractors and maintenance must wear this PPE that differs than the rest of the employees.
What is a hard hat?
This is the minimum height, in inches, required for safety boots at our facility
What is 6 inches?
Traveling with a forklift load raised too high increases the risk of this dangerous event.
What is a tip-over?
Pushing this red button may stop a machine, but it does NOT replace proper energy isolation.
What is the emergency stop button?
These are the people trained to help with injuries and illness, and you can find the names here.
Who are the first responders located on the bulletin board next to the time clocks?
What is red?
These two types of additional types of PPE & equipment is required for applicable work in red zones
What are a Class II high-visablity vest and a two way radio?
A pallet of finished cases is leaning and unstable. This must be done before the pallet can be safely transported.
What is securing or restacking the load?
OSHA defines these as the hazardous energy sources. There are 7.
What are electrical, mechanical, hydraulic, pneumatic, chemical, thermal, stored/gravity?
This is the location of our AED.
What is in the maintenance supervisors, Don's, office?
This type of machine hazard can pull a hand or loose clothing into rotating rollers, even without direct contact with the point where the rollers meet. Be specific.
What is an in-running nip point?
An employee wearing all required PPE notices an exposed moving machine part. This type of safety control, rather than PPE alone, is needed to prevent contact with the hazard.
What is machine guarding? (engineering control)
When a tall load obstructs the forklift operators view this is required to be done.
What is traveling in reverse?
An employee shuts down a machine, isolates its energy sources, applies their lock, and immediately begins servicing it. This critical step must be completed first to confirm the equipment is safe.
What is verifying isolation and a zero-energy state?
When a tornado warning requires employees to take shelter, they must move to this designated location.
What is the tornado shelter located in the old sample room?