HOT! HOT! HOT!🔥🔥🔥
PPE: Pretty Powerful Equipment🥽
Not Today, Gravity
What the Forklift?!
Save Your Back, Jack
100
This type of work can create sparks, flames, heat or ignition sources.
A. Chill Work
B. Hot Work
C. Paperwork
D. Guesswork
B. Hot Work
100
This PPE should be used when noise levels are high enough to damage your hearing.
A. Sunglasses
B. Hearing protection
C. Rain jacket
D. Welding sleeves
B. Hearing protection
100
Fall protection is required in general industry when employees are exposed to a fall of this height or more.
A. 2 feet
B. 4 feet
C. 6 feet
D. 10 feet
B. 4 feet
100
When driving a forklift, this should be worn even if you are only moving a short distance.
A. Safety vest
B. Seatbelt
C. Welding hood
D. Fall harness
B. Seatbelt
100
Twisting while lifting increases the chance of injuring this part of the body.
A. Eyes
B. Lower back
C. Ears
D. Fingers only
B. Lower back
200
Which of the following is a warning sign of heat stress?
A. Dizziness
B. Headache
C. Weakness
D. All of the above
D. All of the above
200
This PPE should be worn when grinding because safety goggles only protect your eyes, not your whole face.
A. Face shield
B. Baseball cap
C. Dust mask
D. Welding jacket
A. Face shield
200
What should happen if a harness has been involved in a fall arrest event?
A. Put it back in storage
B. Use it only for light work
C. Remove it from service
D. Let the next shift decide
C. Remove it from service
200
If a load blocks the operator’s view, the safest action is to do this.
A. Drive forward carefully and hope people move
B. Drive in reverse or use a spotter when needed
C. Raise the load higher to see underneath it
D. Honk once and keep going
B. Drive in reverse or use a spotter when needed
200
If a load is too heavy, awkward, or bulky, what should you do?
A. Lift it faster
B. Get help or use mechanical assistance
C. Drag it with one hand
D. Hold your breath and pull harder
B. Get help or use mechanical assistance
300
Which factor would increase the risk of heat illness the most?
A. Working in shade with water nearby
B. Light-duty work with frequent breaks
C. New employee doing heavy work in high heat
D. Short indoor task near a fan
C. New employee doing heavy work in high heat
300
A worker is welding nearby. Looking directly at the arc without proper protection can cause this painful eye injury.
A. Arc eye / welder’s flash
B. Heat rash
C. Hearing loss
D. A paper cut
A. Arc eye / welder’s flash
300
Before using a harness, employees should inspect it for cuts, burns, broken stitching, damaged hardware, or this.
A. Paint color
B. Missing stickers only
C. Signs of damage or wear
D. Whether it looks expensive
C. Signs of damage or wear
300
This is what you should never do to a forklift unless you want a very bad safety meeting.
A. Ride on the forks
B. Wear your seatbelt
C. Complete a pre-use inspection
D. Use the horn at blind corners
A. Ride on the forks
300
Which is the best way to reduce ergonomic risk when moving a heavy object across the floor?
A. Pull it with your back twisted
B. Push when possible and keep the load controlled
C. Jerk it quickly to get momentum
D. Bend at the waist and drag it
B. Push when possible and keep the load controlled
400
This condition can happen when the body loses too much water and salt from sweating.
WHAT IS DEHYDRATION
400
What is the problem with this container?
It is not properly labeled
400
What should happen before an employee uses a personal fall arrest system for the first time on a task?
A. They should guess where to tie off
B. They should be trained and understand the equipment, anchor point, clearance, and rescue plan
C. They should use whatever equipment is nearby
D. They should tie off only if someone is watching
B. They should be trained and understand the equipment, anchor point, clearance, and rescue plan
400
Forks should be kept in this position while traveling.
A. Raised above eye level
B. Dragging on the floor
C. Low to the ground
D. Fully tilted forward
C. Low to the ground
400
What is the main ergonomic concern with using excessive force during a task?
A. It can increase muscle, joint, and tendon strain
B. It makes the job safer
C. It removes the need for breaks
D. It only affects the hands
A. It can increase muscle, joint, and tendon strain
500
What is acclimatization?
A. Getting used to PPE
B. The body gradually adjusting to working in heat
C. Drinking one bottle of water before work
D. Taking one long break at the end of the shift
B. The body gradually adjusting to working in heat
500
What is the best reason PPE should be treated as the last line of defense?
A. It is useless
B. It only works when selected, worn, maintained, and used correctly
C. It replaces hazard controls
D. It means the job has no hazards
B. It only works when selected, worn, maintained, and used correctly
500
A worker falls and is suspended in their harness. What is the concern if they are not rescued quickly?
A. They may experience suspension trauma
B. They will automatically climb back up
C. The harness becomes stronger over time
D. The anchor point moves closer
A. They may experience suspension trauma
500
A forklift operator is carrying a tall load through a busy area with pedestrians nearby. What is the biggest hazard?
A. The forklift battery may drain
B. The operator may forget where they are going
C. Limited visibility and struck-by risk
D. The load may make the forklift look larger
C. Limited visibility and struck-by risk
500
Which situation creates the highest ergonomic risk?
A. Light object lifted once from waist height
B. Heavy object lifted repeatedly from the floor while twisting
C. Small tool used at elbow height
D. Load moved with a cart
B. Heavy object lifted repeatedly from the floor while twisting